SOYO SY-7ISA quick start Bios Issues

Page 23

SY-7ISAQuick Start Guide

I get distorted video my AGP card right after I save my bios. Why is that?

The cause is likely that your AGP card is not running at the correct bus speed. To fix this, please clear the CMOS via JP5 and if it still does not work, please upgrade your motherboard bios to the latest version.

BIOS Issues

Where can I find the BIOS revision of my mainboard?

It will be displayed on the up-left corner on the screen during boot-up. It will show as your board type followed by the revision number, such as 5EH_2CA1 (meaning revision 2CA1 for the SY-5EH board) or 6BA+ IV_2AA2 which means SY-6BA+ IV motherboard with 2AA2 bios.

Where can I find the latest BIOS of my motherboard?

Please go to the technical support page of one of the SOYO websites (Taiwan: www.soyo.com.tw), and look up your motherboard to find the latest BIOS revision.

Hard disk, floppy drive, CD-ROM etc

When I boot up my new computer I got "floppy boot failure" and the LED on the floppy stays on

Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't trust the "key lock" or "notch") and use the end-connector of the cable (don't use middle one).

Modem issues

I get an "I/O Conflict" message when I turn on my system and I can not get my modem to work

What you need to do is to disable 'COM2' (or UART2 or serial port 2) in the bios under integrated peripheral setup.

I have installed my modem drivers several times and I still cannot get my modem to work. Why?

If you are sure that the modem driver has been installed correctly, then you need to install the south bridge driver from the SOYO CD, this is because Windows does not properly recognize relatively new chipsets.

Audio Issues

I do not get any sound from my sound card. What could be wrong?

Please make sure the speaker is connected to the speaker out port on your sound card.

23

Image 23
Contents Quick Start Guide SY-7ISA Motherboard Introduction SY-7ISA Motherboard Layout Key Features Installation FSB 133MHz Install the CPUFSB 66MHz FSB 100MHzPin1 Pin2 Pin3 Pin4 ATX Power On/Off PwrbtATX Power Supply ATX PW Connections to the MotherboardEnable/Disable Power-On by Keyboard JP1 Stand-by indicator LED LEDConfigure Memory Speaker Option JP22 CNR MR Card-CODEC Option JP8Cmos Clear JP5 CPU Frequency Settings JP6, JP7, CJ1 and CJ2Code Explanation Debug LEDsSelect Frequency/Voltage Control Select Standard Cmos FeaturesSelect Load Optimized Defaults Select Save & Exit SetupSoyo CD Start Up Program Menu Insert the Soyo CD into the CD-ROM driveInstall Drivers and Utilities Short description of all available drivers follows Driver Installation Menu7ISA ITE hardware doctor for Win 9X/2000/NT Check the Latest ReleasesSigmatel Audio Driver Installation SynthCore Lite Application for Windows NT Installing the Software General Installation Notes Intel 815 VGA Drivers Installation For WindowsVerifying the Installation of the Software Quick Trouble shoot tips Bios Issues Can not get my board to run properly Soyo USA Soyo Korea Page SY-7ISA Serial