Clear Cmos Data JP5, At least 5 seconds | SOYO SY-6VBA 133 instruction

SY-6VBA 133 Quick Start Guide

Step 10. Clear CMOS Data (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds, and then by shorting pin 1-2 to retain new settings. This jumper can be easily identified by its white colored cap.

CMOS Clearing	Clear CMOS Data			Retain CMOS Data
JP5 Setting	Short pin 2-3 for			Short pin 1-2 to
JP5 Setting	at least 5 seconds			retain the new
	at least 5 seconds			retain the new
	to clear the CMOS.			settings.
	1	2	3	1	2	3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

Note on Over-clocking Capability

The SY-6VBA 133 provides over-clocking capability. Due to the over-clocking setting your system may fail to boot up or hang during run time. Please perform the following steps to recover your system from the abnormal situation :

1.Turn off system power (If you use an ATX power supply, and depending on your system, you may have to press the power button for more than 4 seconds to shut down the system.)

2.Set the JP8 and JP9 to short if you use a FSB 66MHz CPU

3.Press and hold down the <Insert> key while turning on the system power. Keep holding down the <Insert> key until you see the message of the CPU type and frequency shown on the screen.

4.Press the <Del> key during the system diagnostic checks to enter the Award BIOS Setup program.

5.Select [SOYO COMBO SETUP] and move the cursor to the [CPU Frequency] field to set the proper working frequency.

6.Select [Save & Exit SETUP] and press <Enter> to save the new configuration to the CMOS memory, and continue the boot sequence.

Note: SOYO does not guarantee system stability if the user over clocks the system. Any malfunctions due to over-clocking are not covered by the warranty.

Hardware	Installation