SOYO SY-6BE+ quick start Clear Cmos Data JP5, Cmos Clearing, JP5 Setting

SY-6BE+Quick Start Guide

Step 6. Clear CMOS Data (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds, and then by shorting pin 1-2 to retain new settings. This jumper can be easily identified by its white colored cap.

CMOS Clearing	Clear CMOS Data	Retain CMOS Data
	Short pin 2-3 for	Short pin 1-2
JP5 Setting	at least 5 seconds	to retain the
	to clear the CMOS. 1 2 3	new settings.	1 2 3

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

Note on Over-clocking Capability

The SY-6BE+ provides over-clocking capability. Due to the over-clocking setting your system may fail to boot up or hang during run time. Please perform the following steps to recover your system from the abnormal situation :

1.Turn off system power. (If you use a ATX power supply, sometimes you have to press the power button for more then 4 seconds to shut down the system)

2.Press and hold down the <Insert> key while turning on the system power. Keep holding down the <Insert> key until you see the message of the CPU type and frequency shown on the screen.

3.Press the <Del> key during the system diagnostic checks to enter the Award BIOS Setup program.

4.Select [SOYO COMBO SETUP] and move the cursor to the [CPU Frequency] field to set the proper working frequency.

5.Select [Save & Exit SETUP] and press <Enter> to save the new configuration to the CMOS memory, and continue the boot sequence.

Note: SOYO does not guarantee system stability if the user over clocks the system. Any malfunctions due to over-clocking are not covered by the warranty.

Hardware Installation

9