Hardware | Installation |
|
|
Step 3. Configure Memory
Your board comes with three DIMM sockets, providing support for up to 768MB of main memory using DIMM modules from 8MB to 256MB. For 66MHz front side bus CPUs use 12ns or faster memory; for 100MHz front side bus CPUs use 8ns (100MHz, PC100 compliant) memory.
Memory Configuration Table
Number of Memory Modules |
| DIMM 1 |
| DIMM 2 |
|
| DIMM 3 |
|
|
|
|
|
|
|
|
1 |
| 1st |
|
|
|
|
|
|
|
|
|
|
| ||
2 |
| 1st |
| 2nd |
|
|
|
|
|
|
|
|
| ||
3 |
| 1st |
| 2nd |
|
| 3rd |
|
|
|
|
|
|
|
|
RAM Type |
|
|
| SDRAM |
| ||
Memory Module Size (MB) |
| 8/16/32/64/128/256 Mbytes |
| ||||
Note:(1) 256 MB memory modules only available on PC registered DIMM.
(2) Always install memory modules in the order prescribed in this table.
(3) Do not install unbuffered and registered memory modules together.
Important: It is of prime importance that you install DIMM modules as outlined in the table above in order to preserve signal integrity on 100MHz front side bus systems.
Step 4. Set the CPU Frequency
This Motherboard does not use any jumpers to set the CPU frequency, CPU setting are changed through the BIOS [SOYO COMBO SETUP]. Refer to Chapter 3 “Quick BIOS Setup”for details on how to set the Slot 1 processor frequency.
Step 5. Enable/Disable Power-On by Keyboard (JP10)
You can choose to enable the
Power-On by
Keyboard
JP10 Setting
Enable
Short pin
1 2 3
Disable
Short pin
1 2 3
Important: When using the
8