SOYO V1.0 Attach Connectors, Wake-On-LAN Header JP44, Keylock, Speaker, ATX Power On/Off Pwrbt

SY-5EHM/5EH5 V1.x Quick Start Guide

Step 5. Attach Connectors

This section tells how to connect internal peripherals and power supply to the Motherboard.

Internal peripherals include IDE devices (HDD, CD-ROM), Floppy Disk Drive, Front Panel Devices (Turbo LED, Internal Speaker, Reset Button, IDE LED, and KeyLock Switch.), Wake-On-LAN card, VGA card, Sound Card, and other devices.

For more details on how to connect internal and external peripherals to your new 5EHM/5EH5 V1.x Super 7 ™ Motherboard, please refer to 5EHM/5EH5 V1.x Motherboard User's Guide and Technical Reference online manual on CD-ROM.

Connectors and Plug-ins

	IrDA (Infrared Device Header): IR1					Wake-On-LAN Header: JP44
Pin1	Pin2	Pin3	Pin4	Pin5		Pin1	Pin2	Pin3
VCC	None	IRRX	GND	IRTX		5VSB	GND	MP-Wakeup
	CPU Cooling Fan: JP12						USB
Pin1		Pin2	Pin3		Connect your USB devices to this header.
GND		12V	NC

Power LED Key Lock				Speaker			Power LED		Keylock
+	_		+	_		Pin1	Pin2	Pin3	Pin1	Pin2
						5V	NC	GND	Control Pin	GND
			+ _ + _					Speaker
						Pin1	Pin2		Pin3	Pin4
Reset		PWRBT Turbo LED HDD LED				5V	NC		NC	Speaker out
HDD LED				TB LED			PWRBT		RESET
Pin1		Pin2		Pin1		Pin2	Pin1	Pin2	Pin1	Pin2
LED Anode		LED	LED Anode			LED	Power	GND	Power	GND
		Cathode			Cathode		On/Off		Good

ATX Power On/Off: PWRBT

Connect your power switch to this header (momentary switch type).

To turn off the system, please press this switch and hold down for longer than 4 seconds.

ATX Power Supply: ATX PW

Attach the ATX Power cable to this connector.

Please make sure the ATX power supply can take at least 720mA load on the 5V standby lead (5VSB), if you want to use the advanced power management functions like Power-On by modem or WOL.

Note: Use only ONE type of power supply. If an AT power supply is used, do not attach an ATX power supply.

AT Power Cable

Connect the AT Power cable to this connector. If you use AT power supply.

Installation

13