SOYO SY-P4RS300 quick start HDD LED Pwrbt Reset

Page 12

Installation

SY-P4RS300 Quick Start Guide

		HDD	Speaker					Speaker
PWRBT	Reset LED		Speaker			Pin1	Pin3	Pin5	Pin7
						Pin1	Pin3	Pin5	Pin7
						VCC	NC	NC	Speaker out
							Power LED
PWRBT	Reset HDD LED Power LED					Pin2		Pin4	Pin6
						3V3SB		GND	GND
	HDD LED				PWRBT			RESET
Pin11		Pin12		Pin17		Pin18		Pin13	Pin14
LED Anode		LED Cathode		Power On/Off		GND		GND	Control PIN

Power On/Off: PWRBT

Connect your power switch to this header (momentary switch type).

To turn off the system, press this switch and hold down for longer than 4 seconds.

ATX 12V Power Supply: ATX PW

Attach the ATX 12V Power cable to three connector. (This motherboard requires an ATX 12V power supply, an AT or ATX power supply can NOT be used.)

When using the Power-On by Keyboard function, please make sure the ATX power supply is able to provide at least 720mA on the 5V Standby lead (5VSB).

12

Image 12

Contents Quick Start Guide Soyo SY-P4RS300 Motherboard Introduction UnpackingSY-P4RS300 Motherboard Layout PRTKey Features CPUInstallation Install the Motherboard Install the CPUFront Side Bus Frequency Selection JU200/JU201 Configure Memory Dram voltage Jumper JU2400Installation of Expansion Cards Connections to the MotherboardHDD LED Pwrbt Reset Clear Password Jumper JU601 Cmos Clear JU600Quick Bios Setup Select Load Optimized DefaultsSoyo CD Insert the Soyo CD into the CD-ROM driveSoyo CD Check the Latest Releases USB2.0 Driver Installation Installing the USB2.0 Drivers under Windows XPBoot-up Issues System power-up, no video, beeping heardSystem turns on for some seconds then shuts down by itself Stability Issues My system intermittently locks up, very unstableBios Issue Where can I find the Bios revision of my mainboard?After flashing the BIOS, my system will not boot-up VGA Issue Audio IssueHard disk/FDD/ CD-ROM issues LAN Issues Have problems installing Novell NetWareHow to contact us Taiwan