Hard disk/FDD/ CD-ROM issue

SY-P4VDAQuick Start Guide

I cannotgetthesound workingonmysystem.

1.Check if the speaker wire is connected to the line out connector in the M/B.

2.Check if the speaker power is powered on.

3.Install the audio driver supplied on our driver disc.

4.Check BIOS setup if “onboard audio” is enabled.

5.If sound already installed, check our website for audio driver update.

The sound is working in my system, but when I play CD music from the CD-ROM, I do not get anysound.Whatis wrong?

This is because the 3-wire audio cable fromthe CD-ROM to the on-board CDIN connector in the M/Bis not connected. See manual for location of CDIN.

Thesoundfrommysoundcardisdistorted whenWindowsstart.What is wrong?

If you are using an ISAsound card, please make sure the IRQ needed for the sound card is set to 'Legacy ISA'in the BIOS. In other word, if your ISAsound card takes IRQ5, then set IRQ5 to 'Legacy ISA'.

Thesoundandeverythingelseworksfineexceptthattherecorderandmicrophonedo not work.What is wrong?

1.Please go to sound properties and check if the recorder and microphone in the are enabled.

2.Check if Microphone is ok.

MyWestern digitalHDD is not detected duringboot-up orNo fix disk present.

Change the jumper settings to cable select or single or remove the jumpers.

Sometimesthesystem finds my CD-ROM,sometimes not.

1.Check CD-ROM if it is working properly.

2.The power supply might not have enough wattage to support all the peripherals. If your systemhasotherperipheralsconnected,likeCD-RW,extraHDD,etc.disconnectthem.

WhenIboot upmynewcomputerI got "floppy boot failure" andtheLED onthe floppystayson.

Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't