TANNOY iwSA 500
8.0 PROTECTION FEATURES
8.1 Limiter Function
The limiter function is included to prevent dangerous clipped signals reaching the speaker and damaging it. If an amplifier is severely overdriven, its output waveform is clipped (its peaks are squared off) - reducing the crest factor. In extreme cases the waveform can approach that of a square wave. An amplifier is normally capable of producing far more power under these conditions than its normal undistorted rated output power.
The Tannoy iwSA 500 Amplifier has two modes of thermal protection and an auto shut down when an internal fault is detected.
It is important to have the limiter function switch in the correct position for the number of subs connected, as it sets the amount of output power before limiting occurs.
9.0 MAINTENANCE
Under normal use the amplifier should provide years of
10.0 TROUBLESHOOTING
These are typical things to check if you think your amplifier is faulty:
FAULT: No power indicator light
•Check for proper voltage at receptacle.
•Make sure power cord is properly seated in connector on the rear of the amplifier.
•Check power switch on back of amplifier.
•Check fuse located in holder/drawer below power input connector on back of amp.
FAULT: No output
•If the power indicator light is on, verify that there is a usable signal on the input.
•Check position of level control knob on the front of the amplifier.
•Check speaker cable connections on the output binding posts for bad connections.
•Check speaker cables for possible short circuits.
FAULT: The amplifier does not respond even after having checked the above items.
In the unlikely event of a
Tannoy cannot be held responsible for damage or injury as a result of the top or bottom cover being removed.
11.0 WARRANTY
No maintenance of Tannoy products is necessary.
All of our products have been produced and tested with care and precision to give
All passive components are guaranteed for a period of five years from the date of purchase from an authorized Tannoy dealer subject to the absence of evidence of misuse, overload or accidental damage.
All active and electronic components are guaranteed for a period of one year from the date of purchase from an authorized Tannoy dealer subject to the absence of, or evidence of, misuse, overload or accidental damage.
If at any time during this warranty period the equipment proves to be defective for any reason other than accident, misuse, neglect, unauthorized modification or fair wear and tear, we will repair any such manufacturing defect or, at our option, replace it without charge for labour, parts or return carriage.
If you suspect a problem with a Tannoy product then, in the first instance, discuss it with your Tannoy dealer. If you require further assistance then we ask that you deal directly with your local Tannoy distributor.
For spares and service in NORTH AMERICA only:
Contact: Customer Service Manager inquiries@tannoyna.com Telephone: 519.745.1158
DO NOT SHIP ANY PRODUCT TO TANNOY WITHOUT PREVIOUS AUTHORIZATION
8