SIIG 04-0322B manual Windows 2000 Driver Installation, For New Windows 2000 Installation

Page 8

Windows 2000 Driver Installation

A new installation of Windows 2000 requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the Floppy folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

For New Windows 2000 Installation

1.Install the board and follow Microsoft procedures to install Windows 2000 accordingly.

2.Restart your system when prompted during Windows' installation.

3.At the Windows 2000 Setup screen, press F6 to install the driver.

4.Insert the driver diskette. Press S, then press Enter.

5.Select Silicon Image SiI 3114 ... Controller for Windows NT 4.0 and 2000, and press Enter.

6.Press Enter to continue and follow on-screen instructions to complete the installation.

For Existing Windows 2000 Installation

1.Install the board and boot up Windows 2000.

2.At the Found New Hardware Wizard, click Next.

3.Select Search for a suitable driver for my device (recommended) and click Next.

4.InsertthedriverCD,checkCD-ROMdrives,uncheck the other boxes, and click Next. Click Next again to continue.

Note: If a warning message pops up, click Continue Anyway, then click Finish. Our driver has been thoroughly tested in Windows for stability.

5.Click Finish, remove the driver CD and restart Windows to complete the driver installation.

8

Image 8
Contents Features and Benefits System RequirementsBoard Layout Hardware InstallationPackage Contents Device Connection Hard disk drive connectionsFor New Windows 98 Installation Software InstallationWindows 98/98SE Driver Installation Windows ME Driver Installation For Existing Windows 98 InstallationFor New Windows ME Installation Select Search for a better driver ... and click NextVerify Proper Installation for Windows 98/ME Windows NT4.0 Driver InstallationFor Existing Windows ME Installation For New Windows NT4.0 InstallationVerify Proper Installation for Windows NT4.0 For Existing Windows NT4.0 InstallationFor Existing Windows 2000 Installation Windows 2000 Driver InstallationFor New Windows 2000 Installation For Existing Windows XP/Server 2003 Installation Windows XP/Server 2003 Driver InstallationFor New Windows XP/Server 2003 Installation Select Device Manager Bios ConfigurationVerify Proper Installation for Windows 2000/XP/ Server Technical Support and Warranty SIIG, Inc Stewart Avenue Fremont, CA 94538 RMA #About SIIG, Inc