Important Safety Instructions
NOTE: The jump start switch must be in the OFF position before using the inverter.
•The PP-18400CI comes with an internal inverter. It must be well ventilated in order to properly disperse heat while it is in use. Make sure there are several inches of clearance around the top and sides of the PP-18400CI. do not block the vents on the back of the PP-18400CI.
•Make sure the PP-18400CI is not close to any potential source of flammable fumes, gases or clothing.
•Keep the PP-18400CI dry.
•DO NOT allow the PP-18400CI to come into contact with rain or moisture.
•DO NOT operate the PP-18400CI if you, the PP-18400CI, the device being operated or any other surfaces that may come in contact with any power source are wet. Water and many other liquids can conduct electricity, which may lead to serious injury.
•Do not place the PP-18400CI on or near heating vents, radiators or other sources of heat.
•Do not place the PP-18400CI in direct sunlight.
•The ideal air temperature for operation is between 50° and 80°F.
•Do not use inverter near open engine compartment.
•Do not modify the AC receptacles in any way.
USING THE INVERTER
It is important to know the continuous wattage of the device you plan to use with the inverter. The PP-18400CI must be used with devices drawing 400 watts or less. If the wattage is not marked on the device, an estimate can be made by multiplying the AC input current (Amps) by the AC voltage (110V).
Devices like TVs, fans or electric motors require additional power to start (com- monly known as the “starting or peak power”). The PP-18400CI can supply a momentary surge in wattage; however, even devices rated less than the maxi- mum 400 watts can exceed the inverters surge capability and cause an automatic overload shutdown.
Make sure the device you are using is compatible with a modified sine wave inverter.
CAUTION: Always run a test to establish whether the inverter will operate a particu- lar piece of equipment or device.
NOTE: In the event of a power overload, the inverter is designed to automatically shut down. This safety feature prevents damaging the inverter while testing de- vices and equipment with the 400-watt range.
IMPORTANT: When powering two-110 volt AC accessories, the combined watts should not exceed 400 watts.
