Vintage

Pre Delay

Range: 0-500ms (Vintage values: 0, 20, 40 and 60ms)

Pre delay is the amount of time from an input is received until reverb starts building up at the output.

Modulation

Range: 0% – 200% (default: 100%)

Sets the Depth of the modulation. Normal set to 100%. Increase if you like a more liquid, chorus like sound.

Hi Cut

Range: 8kHz – 13kHz (default: 11kHz)

This is DVR2´s HiCut and can be used to limit or extend the overall frequency spec- trum.

Q Scale

Range: 0.3 – 1.4 (default: 1.2)

Corresponds the small potmeters inside older reverbs used to equalize sound differ- ences caused by electric component-tolerances. Use the Q-scale in combination with the HiCut Frequency to shape the treble to your personal flavor.

Input Trans

Range: on/off (default: off)

Emulates the sound of Input transformers typically used in vintage Reverbs. Use it to create a warm vintage like sound. Especially good for short Decay times.

Trim Lo Freq

Range: on/off (default: on)

A subtle damping of selected frequencies in the lower end.

Lo Res

Range: on/off (default: on)

Switches the DVR2 to a lower bit-resolution. This adds an older and more grainy sound and also noise giving a simulation of various vintage reverbs.

Vintage Reset

Clicking on this button will reset the controls in the “Vintage” section back to the val- ues as they are found on the vintage original.

E N G L I S H

DVR2 / 9