Troubleshooting & Service
If you should experience a problem with the operation of your subwoofer, please check all of the following before seeking service. Following is a simple troubleshooting guide to assist you.
1.Verify unit is plugged in and power outlet used is active.
2.Is power switch on?
3.Is auto turn on/off set properly?
4.Is unit receiving an input signal from your source?
5.Have all controls on subwoofer (volume, crossover, phase, etc.) been properly set?
6.Is the mute on the remote control engaged?
7.Are both volume controls properly set?
8.If unit has been running at high levels for an extended period of time, one of the protection circuits may be engaged.
•Has the
•Is your power line voltage sagging under heavy use?
If the protection circuitry is active, the unit may cycle on and off until operating parameters return to normal. Protection circuit operation is usually indicated by a blinking power led. Under more serious conditions, the unit may shut off completely. Normal operation will return upon cooling, but you may be required to turn the power off and then on again to reset the unit.
The following conditions require service by a qualified technician:
1.The power cord has become damaged.
2.The unit does not appear to operate normally or exhibits a marked change in performance.
3.The unit has been exposed to water.
4.Some part of the cabinet or circuitry is physically damaged.
Thank you for purchasing a Velodyne!
Congratulations!
Congratulations on your purchase of a Velodyne servo controlled subwoofer system. This system represents the state of the art in accurate low frequency reproduction. We believe these units to be some of the finest sounding subwoofers available. When properly cared for, this exceptional subwoofer will provide you with years of unparalleled listening pleasure. Enjoy!
Caution!
Please observe the following instructions to insure safe and proper system operation.
Warning!
To prevent fire or shock hazard, do not expose this equipment to rain or moisture. To avoid electrical shock, do not open speaker enclosure or amp chassis cover. Please observe all warnings on the equipment itself. There are no user serviceable parts inside. Please refer all service questions to your authorized Velodyne dealer.
Prior to installation
Please unpack the system carefully! This unit is extremely heavy. Use caution when lifting of moving to avoid injury. Remove all staples used to seal the carton as they can scratch the cabinet. Please save the carton and all packaging materials for future use. Packing this unit in any other carton may result in severe damage when shipping. Please take a moment to record the serial number and date/location of purchase in the space provided on the warranty card for future reference.
Note: Do not move unit while power is on. You may damage the Servo Control circuitry!
continued. . .
|
|
|
|
13 | ☞ | 2 | ☞ |
|
|
|
|