Velodyne Acoustics DD-12+, DD-18+, DD-15+, DD-10+ manual System Response Screen with Self-EQ Selected

Page 34

TV SCREEN USER INTERFACE FOR OPTIMIZATION

Digital DrivePLUS User Interface Manual

Figure 15: System Response Screen with Self-EQ Selected

8)You can watch the subwoofer smooth its frequency response by adjusting the parametric EQ filters on the System Response screen. Self-EQ doesn’t change the Setup preset parameters (volume, crossover, etc.) and uses the crossover set to 160 Hz.

9)When Self-EQ finishes, the sweep tones stop, the front status message shows End for 10 seconds, the subwoofer reboots by turning itself off and back on. The subwoofer display shows the preset number and then volume level. During this process the new filter settings are saved into the subwoofer’s memory.

Running Auto-EQPLUSOptimization – Stepping Up in Power

The next level up in the Digital DrivePLUS EQ optimization methods is Auto-EQPLUSoptimization. To perform Auto-EQPLUSoptimization:

1)Set up the microphone as in the Self-EQ instructions above.

2)Connect your subwoofer to your TV video input as described above in the Make Video Connection between TV and Subwoofer section.

3)Make sure the subwoofer and your audio system are both on.

4)Place the Digital DrivePLUS Sweep Tone CD into your disc player and press play.

5)Once the sweep tone starts to play, adjust the receiver or processor output level to about the level of a normal-loudness conversation at the mic.

6)Press and hold EQ on the remote until Auto-EQPLUSstarts; you will see on the System Response screen the AUTO option in the EQ MODE area. See Figure 16.

The Auto-EQPLUSproceeds until one of the following occurs:

•Auto-EQPLUSfinishes successfully, saving the settings.

•You decide to quit, and press RESET on the remote. You exit back to the Introductory screen, you don’t see the Auto-EQPLUSfrequency response curve any more.

•You move the cursor off the AUTO field (in which case the field automatically reverts to Manual-EQ).

•The frequency response level is too high (peaks over 87 dB) or too low (average level below 70 dB).

•The Sweep Tone CD stops playing.

7)The Digital DrivePLUS subwoofer not only adjusts the Setup preset EQ filter levels as you watch, but it also adjusts the subwoofer level, crossover, slope, and phase during the Auto-EQPLUSoptimization process.

8)You can also watch the status messages during the process in the upper left hand corner of the TV screen.

[ 32 ]

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Digital DrivePLUS I V E R U P D a T E S Introduction Part Three Software & Driver UpdatesManual Organization Windows Interface for Optimization Velodyne’s Digital DrivePLUS Windows Setup SoftwarePart ONE Virtual COM Port DriverSupported Windows Software Installation RequirementsAvailable Hard Drive Space Display Resolution Operating SystemsWindows Interface for Optimization Windows Interface for Optimization Windows Interface for Optimization Windows Interface for Optimization Windows Interface for Optimization Click Install Digital Drive Plus Windows Setup Program User Interface Frequency Response and Parameters ScreenOptimization Parameters GraphsEQ Optimization Option Selection and Initiation Status Information Save Setting OptionsSubwoofer Controls Menu File MenuPreset Screen Preset ScreenMaking & Saving Preset Changes Running SELF-EQ OPTIMIZATION- Your First EQRunning AUTO-EQPL US Optimization Stepping UP in Power Running Manual EQ Optimization Adjust IT to Your LikingWindows Interface for Optimization Troubleshooting Guide SolutionClick Uninstall a program under Programs Uninstalling the Virtual COM Port Software Select Uninstall Click UninstallPart TWO ScreensTV Screen User Interface for Optimization System Response Screen Status MessagesTips for Using the TV Screen Controls System Settings ScreenScreen Controls Remote Control Button Commands Go to the System Response ScreenGo to the System Settings Screen Lock the Setup Preset Restore DefaultsSave Settings Select a PresetMake & Save Preset Changes Change Default PresetSet Parametric Equalizer Filter Parameters System Response Screen Modified 32 Hz EQSystem Response Screen Modified 63 Hz EQ Running Self-EQ Optimization Your First EQRunning Auto-EQPLUSOptimization Stepping Up in Power System Response Screen with Self-EQ SelectedSystem Response Screen Auto Eqplus Mode Running Manual EQ Optimization- Adjust it to Your LikingIntroductory Screen Runtime Inactive Modes Standby ModePerform Listening Test Power Off Mode Waiting for 12 Volt Trigger ModeDefeat Subwoofer’s Low Pass Crossover Filter Software & Driver Updates Part ThreeVelodyne Acoustics, Inc

DD-10+, DD-12+, DD-15+, DD-18+ specifications

Velodyne Acoustics is well-known for its innovation in the field of audio technology, particularly in subwoofers. Among the standout products in its lineup are the DD-15+, DD-10+, DD-18+, and DD-12+ subwoofers. These models are designed to deliver extraordinary bass performance with precise control and clarity, catering to both home theater enthusiasts and audiophiles alike.

The DD-15+ is a powerful subwoofer boasting a 15-inch driver that produces deep, impactful bass. One of its most notable features is its Smart Digital Amplification, which delivers a robust output of 1,500 watts of peak power, ensuring the playback of dynamic soundtracks is powerful without distortion. The DD-15+ offers an advanced, user-friendly interface, including a built-in automatic room tuning system. This feature measures the room acoustics and automatically adjusts the subwoofer's settings for optimal sound, ensuring that your audio experience is tailored to your environment.

The DD-10+ is a more compact model but does not compromise on performance. Featuring a 10-inch driver, it delivers exceptional bass response in smaller spaces. Its high-efficiency amplifier provides 800 watts peak power, making it capable of delivering thrilling low-end sound for movies and music alike. Like its larger counterparts, the DD-10+ comes equipped with room calibration technology, ensuring it can adapt to various listening environments seamlessly.

The DD-18+, with an impressive 18-inch driver, positions itself as a powerhouse capable of producing the deepest bass frequencies with authority. Its peak power rating of 2,000 watts makes it one of the most formidable subwoofers on the market, capable of handling the most demanding soundtracks. This model also incorporates Velodyne's patented Digital Drive DSP technology, allowing for precise control of the bass output and minimized distortion, even at high volumes.

Lastly, the DD-12+ combines power and precision with its 12-inch driver and 1,200 watts of peak power. This model is designed to deliver well-defined low frequencies across a wide range of audio content. Just like the other DD models, it also features room correction technology that fine-tunes performance based on the room's unique acoustics, ensuring that users experience the best possible sound.

All four models share key characteristics such as a sleek design, versatile connectivity options, and customizable settings. They cater to various user preferences while ensuring an unmatched audio experience. Velodyne’s dedication to innovation and quality is evident in the DD series, making them a top choice for anyone seeking to enhance their audio setup.
Top Page Image Contents