Windows 64-Bit

Installation

Windows

It is necessary to install driver software in order for Windows to recognize the IF-FW/ DM. An installer is provided for this pur- pose, the drivers cannot be installed manu- ally from Windows Device Manager. On the CD-ROM that came with your IF-FW/DM is a PC Driver installer. Launch the installer from the CD or copy it to your hard drive and launch it from there. The installer is launched by clicking “setup.exe”.

NOTE

The IF-FW/DM should be disconnected from the PC to begin driver installation.

1.Launch the driver installer and carefully follow the on-screen instructions in the

Installation Wizard.

2.When presented with any Windows Logo warnings, click Continue Anyway.

3.Follow the steps on all screens of the

Installation Wizard through the Windows “New Hardware Wizard”.

•You will be prompted to connect the IF-FW/DM to the computer at this point.

4.The New Hardware dialog will appear in the lower right of the Windows desktop.

5.When presented with any Windows Logo warnings, click Continue Anyway.

6.Installation activity will continue in the New Hardware dialog in the lower right of the Windows desktop. Do not click on anything during this activity - allow it to finish.

7.“Your new hardware is installed and ready to use” will appear in the lower right of the Windows desktop.

8.Click “Next” in the Setup/Installation window.

9.The Setup/Installation window will pres- ent a “Finished” message. Click Exit.

10.Your IF-FW/DM is installed and ready to use.

Windows driver version 1.10 & higher includes untested 64-bit drivers (requires 64-bit PC hardware and 64-bit Windows OS). This is not officially supported.

TASCAM IF-FW/DM Owner's Manual