Sceptre Technologies X20WG-Naga user manual FCC Warning

Page 2

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inerference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution:

i

Image 2
Contents X20WG-Naga FCC Warning Radio Frequency Interference Statement Table of Contents Unpacking LCD MonitorYour New LCD Monitor Rev.3 Sceptre logo Indicator Identifying ComponentsHot Keys for Quick Adjustment of Monitor Settings Adjusting the Tilting Angle Tilting the MonitorPower Management System PC conenctionHow to install the detacheable stand Display Controls LCD Monitor’s Control PanelOSD Main Screen Auto Adjust Option Rev.3 Rev.3 Rev.3 Out of Range TFT LCD Monitor Specifications Appendix aON/OFF, W Appendix B Supported PC TimingSupported Video mode Troubleshooting Appendix CProblem The LCD displays signal out of range error message