Schlage RS485 manual FCC Compliance & Warnings

4.FCC Compliance & Warnings

4.1FCC Compliance

•This device has been authorized by the FCC Rules and Industry Canada.

•This device complies with the limits for a Class B digital device and a Class B intentional radiator, pursuant to Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

•The Wyreless Access System Component must be installed by qualified professionals or contractors in accordance with FCC part 15.203, Antenna Requirements.

•Do not use any antenna other than the one provided with the unit.

4.2Warnings

•RF Exposure - To comply with FCC RF exposure requirements for mobile transmitting devices this transmitter should only be used or installed at locations where there is normally at least a 20 cm separation between the antenna and all persons.

•Do not co-locate and operate in conjunction with any other antenna or transmitter.

•Use only the Battery Pack specified in this instruction manual.

•Do not subject Battery Pack to fire or high temperatures.

•Do not attempt to recharge, short out or disassemble Battery Pack.

•Follow local regulations for alkaline battery disposal.

•Immediately remove the batteries and discontinue use if:

-the product is impacted after which the interior is exposed, or

-the product emits a strange smell, heat, or smoke.

•Changes or modifications not expressly approved by Schlage, could void the users authority to operate the equipment.

IR Security & Safety

	575 Birch St., Forestville, Connecticut 06010 / (860) 584-9158 / (860) 584-2136 fax
P/N: M053-016-A	http://www.irsupport.net	Page 14 of 15