Copy Paper
Important
❒Use of damp or curled paper may cause a misfeed. If a misfeed occurs, try turning over the paper stack in the paper tray. If there is no improvement, change to copy paper with less curl.
Note
1
❒Postcards should be fed from the bypass tray.
❒When printing on envelopes, note the following:
•Load envelopes with the copy side face down on the bypass tray.
•Check that envelope flaps are securely folded up.
•Make sure that there is no air between envelopes.
•Load only envelopes of the same size and type at the same time.
•Before loading envelopes, flatten the leading edge (the side being fed into the machine) by running a pencil or ruler across them.
•Use only rectangular envelopes.
❒If you load paper of the same size and in the same direction in two trays, the machine automatically switches to another tray when the tray in use runs out of paper. This function is called Auto Tray Switch. This saves interrupting a copy run to replenish paper even when you make a large number of copies. You can cancel this setting. The optional paper tray unit is required to use this setting. See “10Auto Tray Switch” of the System Settings manual.
Reference
If you want to add paper, see p.42 “ hLoading Paper”.
If you want to change the paper size, see p.48 “Changing the Paper Size”.
Non-recommended Paper
RCAUTION:
•Do not use aluminum foil, carbon paper, or similar conductive paper to avoid a fire or equipment failure.
Important
❒Do not use any of the following kinds of paper or a fault might occur.
•Thermal fax paper
•Art paper
•Aluminum foil
•Carbon paper
•Conductive paper
❒Do not use copy paper that has been already copied on. Otherwise, a paper misfeed might occur.
13