Velodyne Acoustics SC-8 Subwoofers user manual S ta l l a t i o n

Page 9

SC-IF/SC-IC (In-Floor/In-Ceiling):

-12” (9.7” piston diameter) subwoofer

-3” high temperature inside/outside voice coil

-Oversized spider for linearity at high excursion

-High-excursion EPDM rubber surround

-162 ounce magnet/346 ounce motor structure

-Magnetically shielded for video use

-Frequency Response: 22 - 120Hz (+/- 3 dB)

-8 ohm impedance

I n s ta l l a t i o n

Your new Velodyne amplifier provides for a number of installation options. Read all the installation information below in order to determine which installation option is best for your system. Remember to perform all installation procedures with system power turned off.

FRONT PANEL CONTROLS AND DISPLAYS

Figure 1: Front Panel Connections of the SC-1250.

Following are brief descriptions of the controls described in Figure 1. More detail on these controls can be found in the next section.

(1) Power Switch

This push button style switch is the main on/off for the unit.

(2) Power LED

This LED illuminates when the power is on. Blue is normal operation. It turns amber when the unit is in standby mode or the remote has been used to deactivate the unit. This LED dims when the unit is in night mode.

(3)

Mic Input

 

Connect the supplied microphone for the Auto-EQ feature to this mini-jack.

(4)

Remote Eye

 

This is the eye that receives infrared commands from the supplied remote.

.w w w . v e l o d y n e . c o m

SubContractor User’s Manual

3

Page 8 Page 10
Image 9
Page 8 Page 10
Contents
SubContractor Series U t i o n At t e n t i o n Vo r s i ch t At t e n z i o n e Table of Contents Prior to Installation Product FeaturesN g r a t u l a t i o n s SC 1250 Subwoofer AmplifierSC 8, SC 10, SC 12, SC 15, SC IW, SC IF/IC Subwoofers S ta l l a t i o n Volume Control LED Numeric IndicatorLow-Pass Crossover Optional Rack MountMono LFE Line-Level Connection Line Input / LFE Input See a & 3BStereo Line-Level Connection Balanced XLR LFE Input See Figure IR Input14 12V Trigger Speaker Level Output Terminals See Figure Auto ON/OFF SwitchAbout Low Pass Cr ossovers Wor d About Inter connect Cables Disabling the Low Pass Cr ossover Subwoofer Dir ectWor d About Subwoofer Placement Selecting the Subwoofers to be ControlledModel LED Display Remote Contr ol A g eMusical Style Suggested Preset Preset Subsonic Filter Volume Frequency Restoring DefaultsCare of your Amplifier and Subwoofer DifferentialThank You for Purchasing an SC-1250 Troubleshooting and SER ViceSpecifications Com Por t Setup Appendix a RS-232 Serial Overview and CommandsSC in and OUT Por t Pin Configuration Runtime Command Format Byte Number Byte DescriptionW . v e l o d y n e . c o m Other Velodyne Subwoofer Products Digital DriveSignature Edition Velodyne Acoustics, Inc