Velodyne Acoustics SC-IF/IC installation manual Installation Step By- Step

Page 5

Installation — Step - By- Step

Step 1 -

Determine installation location. As stated above, the SC-IF/IC can be mounted virtually anywhere. The only requirements are that the cabinet fit into the location, and that there be proper venting for the audio to be passed into the listening environment.

Step 2 -

Mark installation location. It is useful to place the subwoofer cabinet in its proposed position and mark the locations of the four brackets that will be used to affix the subwoofer to the framing. Note that the brackets can be mounted ANYWHERE on the subwoofer cabinet, as long as the brackets do not interfere with the woofer’s operation. Always use all four brackets in the installation. It is recommended that the cabinet be positioned flush with the face of the joists for ease of positioning and installation, but this is not required. Make sure the speaker terminals are facing the direction you intend to run the speaker wire.

Figure 1: Mark bracket locations with a pencil.

Note: The brackets can be attached anywhere on the SC-IF/IC cabinet.

.w w w . v e l o d y n e . c o m

SC-IF/IC User’s Manual

2

Page 4 Page 6
Image 5
Page 4 Page 6
Contents SC-IF/IC U t i o n Table of Contents Wor d About Grilles Product OverviewStep Installation Step By- StepMount brackets on subwoofer cabinet Affix foam strips SC-IF In-Floor positioned into floor location Tighten the brackets 6b, and 6c Speaker wire connection Finished installation with register Register. . . on Line . . . It’s faster . . . and easier Other Velodyne Products 110V 230VVelodyne Acoustics, Inc
Top Page Image Contents