Uniden WNP1000 specifications Access Point Configuration, Saving the Configuration, LAN Setup

Page 8

Saving the Configuration

The configuration changes that you make are automatically saved into the flash memory of the WNP1000 Wireless AP within a few seconds after you click the Apply button. However, the WNP1000 Wireless AP will continue to use the previous configuration values until you restart the WNP1000 Wireless AP by clicking the Reboot button on the left manual page.

Each time you make a change, the WNP100 Wireless AP will remind you by displaying a page such as the one shown below:

Access Point Configuration

Through the following procedure, you can enable the wireless operation of the WNP1000 Wireless AP to allow communication between wireless clients and devices on your wired network such as a DSL/Cable modem, printers, file servers, and e-mail servers.

LAN Setup

Click LAN Setup on the left menu. The following page will appear.

Image 8

Contents Table of Contents Installation FeaturesPackage Contents WelcomeInstalling the Hardware Physical InstallationPowering the AP Connecting the Device to Computers and NetworkState Description Setting up the Wireless APLED Display Configuration Interface LoggingGeneral Information Wireless Statistics Password SetupLAN Setup Access Point ConfigurationSaving the Configuration Reset Button MAC AddressLAN IP Address Subnet MaskWlan Setup ChannelWEP Key Configuration WEP EncryptionPassphrase Method Click on Auto Generated from passphraseManual Key Entry Click on Manual Enter in the table belowWlan Access Control MAC Address Access Control Firmware Upgrade Page Page Troubleshooting Changing The IP AddressEnter the Subnet Mask Specifications RJ-45 connectorDouble click on Network Connections Model Number WNP1000Legal Notice IC NoticeFCC Information Statement of ConditionsPrecautions Important Safety InstructionOne Year Limited Warranty Important Electrical ConsiderationsGlossary Page Page Page Page Memo