QqtQI~~.a dFunqions, Cd Cv @ @ @ @ W@ @@@

,(,Qqt"QI~~.a; d<F'unqions

~~~-~~~~~---

~_m__~~~~---

unIden	BANK
~	"34'			@
VOL -!)-SOL	"34'
VOL -!)-SOL	,,-,/-,	/_"~'-'/-'~IC	-'
	,,-,/-,	/_"~'-'/-'~IC
	, L' L'	I ,_, '-'.I-' '-
	PR' L/Q Oli	cOlT HLD se. SRC

Off

CD CV @ @ @ @ W@ @@@

10.Search - Press to search for new ac-

tive frequencies within preset ranges of any band.

11.Lockout/Clear - Press to lockout the reception of frequencies on se- lected channels during scanning. Lockout is retained in memory. Press again to deselect lockout.

Pressing the lockout for 2.5 seconds will clear all the locked out frequen- CIes.

12.Numeric Keypad - ("0-9" and "."J Used to program all frequencies in- to memory and for direct channel access. During the scan mode these keys are utilized to se'lect or deselect any of the 5 memory banks.

13.Enter - The "E"key is used to enter frequencies into the scanning memory.

14.Memory Lock - This unique fea-

ture is used to lock the keypad to prevent accidental entries and is lo- cated on the back panel.

15.External Speaker - The external speaker jack allows you to use an

alternate speaker in case of a high

noise environment. Use Uniden

model ESP 25 external speaker for best results.

16.Tape Out - Thisjack allows you to connect to any standard tape recor- der in order to record transmissions.

1.On/Off, Volume - Turns the unit on or off, and controls the audio output level.

2.Squelch - Eliminates the annoying "rushing" sound that is present be- tween transmissions when no sig- nal is being received. Proper adjust- ment of this control keeps the re- ceiver quiet and allows scanning until a signal is received.

3.Scan - Press to start scanning all fre-

quencies programmed into memory that are not locked out.

4.Manual - Press to stop scanning.

Press again to manually step to the next channel. Press the channel

number and then press the manual key to go directly to that channel.

Priority - The priority key samples channel 1 every two seconds re- gardless of other operational set- tings.

6.Hold - Press to stop and hold the search function on the current fre-

quency. Press again to manually step up to the preceding frequency.

7.Loop Function - Program 5 fre- quency bands L1 to L5.

To program these frequency bands it is only necessary to input an up-

per frequency and a lower frequen- cy to specify a search range within one band.

8.Delay - The delay key provides a 2 second delay on any channel to re- ceive a reply transmission on the same frequency before resuming search or scan. Delay is retained in memory.

9.Limit - Enter the Iow and high li- mits of the search range. Press to

manually step the search frequency down.

(@)

MEMO. LOCK

OFAON~

T DC 138 V

@@@