Wasp Bar Code manual Before You Begin Using Your WDT3200, Installing the Battery Pack, Off

Page 10

WDT 3200 Product Reference Guide

Before You Begin Using Your WDT3200

Before using the WDT3200, please ensure the battery is fully charged. There are three ways to charge your WDT3200:

￿Docking Station

￿RS232/Charging cable or USB/Charging cable

￿Rechargeable Lithium-Ion battery pack

CAUTION: There is a high risk of data loss if the WDT3200's backup battery is not fully charged. This data loss can occur if the main battery has been drained and the unit is not connected to the AC adaptor. For this reason, it is crucial that before you charge the main battery, you make sure the backup battery switch is set to ON. For further information on turning on the backup battery switch, please see the next page.

Wasp Barcode Technologies recommends that you charge the battery at least 12 hours before using for the first time. After the initial charge, a fully drained battery can be recharged in about 4 hours. While charging the main battery the backup battery will also be charged if the backup battery switch is set to “ON”.

Installing the Battery Pack

1.Remove the battery door.

2.Move the backup battery switch to the ON position.

On

Off

10

Image 10
Contents WDT Wasp Barcode TechnologiesTable of Contents Overview SupportWarranty RegulatoryMain Battery Type Weight gDimension LxWxH mm Battery Recharging TimeCommunication and Charging Cable Kits WDT3200 Accessories Communication and Charging CradleLi-ion Battery Pack Universal AdaptorWDT3200 Product Introduction & Accessory Kit WDT3200 Front View WDT3200 Back View Speaker Battery Door Hand Strap StylusSD Memory Slot Installing the Battery Pack Before You Begin Using Your WDT3200Off Using the WDT3200 for the First Time Supplying Power to the WDT3200Pressing the Power ON/OFF Key Setting Time Zone/ Date Adjusting Screen BrightnessAlign the Screen Setting the Time Zone Keypad Tab Key On/Off KeyWDT3200 HotKeys Navigate to Start Programs Utilities RegFuncKeyOther Character Support from WinCE Keyboard Software Keyboard Windows CE KeyboardOpening the Windows CE Keyboard Bar Code Scanner Charging the Lithium-Ion Battery PackCharging the Main and Backup Battery for the First Time Environmental Consideration for ChargingHow to Save Battery Power Power Status IndicationAutomatic shutdown of the WDT3200 Storage and Safety Precautions Backlight SettingWarm Boot Warm Boot / Cold BootWarm Boot via Software Cold Boot via Software Warm Boot via HardwareCold Boot Cold Boot via HardwareConnecting the Serial or USB Cable IntroductionRF Communication Docking StationRS232 / USB Cradle Using ActiveSync RequirementsUsing the Mobile Devices Window Displayed window, you canChanging Communications Settings Scanner Setting Scan2KeyRegistry Backup/Restore