Wasp Bar Code WDT3200 Warm Boot via Hardware, Cold Boot via Software, Cold Boot via Hardware

Page 21

WDT 3200 Product Reference Guide

Warm Boot via Hardware

Use a blunt pin (like an unfolded paper clip) to press the reset pin located on the front of the WDT3200, below the keypad.

Cold Boot

A Cold Boot is used to reset the operating system, restore the terminal back to factory default, and reset the terminal after a BootLoader, keyboard, or kernel upgrade.

WARNING - Performing a Cold Boot will return the WDT3200 to its original factory settings! All installed programs and data will be lost!

Cold Boot via Software

To perform a Cold Boot via software, locate the

BootMode program.

Start - Programs - Utlitities - BootMode.

Tap “Cold Boot”. The system will be re-started and reset back to factory default.

You will need to recalibrate the screen and reset the date and time.

Cold Boot via Hardware

1.Remove the Main Battery.

2.Switch OFF the Backup Battery.

3.Switch the Backup Battery back ON.

4.Insert the Main Battery.

5.The terminal will be cold started and reset back to factory default.

6.Recalibrate the screen and reset the date and time.

21

Image 21

Contents Wasp Barcode Technologies WDTTable of Contents Support OverviewRegulatory WarrantyDimension LxWxH mm Weight gMain Battery Type Battery Recharging TimeLi-ion Battery Pack WDT3200 Accessories Communication and Charging CradleCommunication and Charging Cable Kits Universal AdaptorWDT3200 Product Introduction & Accessory Kit WDT3200 Front View Speaker Battery Door Hand Strap Stylus WDT3200 Back ViewSD Memory Slot Before You Begin Using Your WDT3200 Installing the Battery PackOff Supplying Power to the WDT3200 Using the WDT3200 for the First TimePressing the Power ON/OFF Key Adjusting Screen Brightness Setting Time Zone/ DateAlign the Screen Setting the Time Zone Tab Key On/Off Key KeypadNavigate to Start Programs Utilities RegFuncKey WDT3200 HotKeysSoftware Keyboard Windows CE Keyboard Other Character Support from WinCE KeyboardOpening the Windows CE Keyboard Charging the Main and Backup Battery for the First Time Charging the Lithium-Ion Battery PackBar Code Scanner Environmental Consideration for ChargingPower Status Indication How to Save Battery PowerAutomatic shutdown of the WDT3200 Backlight Setting Storage and Safety PrecautionsWarm Boot / Cold Boot Warm BootWarm Boot via Software Cold Boot Warm Boot via HardwareCold Boot via Software Cold Boot via HardwareIntroduction Connecting the Serial or USB CableDocking Station RF CommunicationRS232 / USB Cradle Requirements Using ActiveSyncDisplayed window, you can Using the Mobile Devices WindowChanging Communications Settings Scan2Key Scanner SettingRegistry Backup/Restore