Connecting the VPA-3528Net to a Computer

ViPowER / VPA-3528Net User`s Manual

Connecting the VPA-3528Net to a Computer

Computer and Systems Requirements

•LAN and USB equipped desktop computer or notebook

•Windows 98SE/Me/2000/XP/NT 4.0, or Mac OS 9.0 or above

NOTE:

Do NOT connect Ethernet and USB cables at the same time.

Ethernet Network Storage Mode

Proceed with the following steps to use the VPA-3528Net Network Storage.

Step 1.

Power on two computer.

Step 2.

Plug one end of the power adapter power cord +12V power adapter into an AC power outlet, and the other end to the +12V power inlet on the rear panel of the VPA-3528-Net NetWork Storage.

Step 3.

Connect one end of the LAN cable into the LAN port connector on the rear panel of the VPA-3528Net NetWork Storage, then plug the other end into a LAN port connector on the back of one of the two computer.

Step 4.

Power ON the VPA-3528Net NetWork Storage. The Power LED indicator on the front panel of the VPA-3528Net will light after a slight delay.

Step 5.

Use the other one computer to setup the VPA-3528Net NetWork Storage.

ViPowER / 3.5-inch Aluminum HDD NetWork Storage