Turbosound NUQ-6, B-12DP Use as Monitor Wedges, Self-powered Loudspeakers, Networking Capability

Quickstart Guide

NuQ series

Turbosound LMS-D2X controllers provide factory presets for all NuQ systems, downloadable from the Turbosound website, as well as additional user program slots.

1.Power up the controller(s) and associated power amplifiers.

2.Press RECALL to select the appropriate program from the preset menu using the ‘A’ ROTARY ENCODER.

3.Press RECALL again to accept the preset. The controller will un-mute and is then ready for use.

Use as Monitor Wedges

NuQ 2-way systems double effectively as wedge monitors. The NuQ-6 provides both 33° and 45° wedge angles while all other models feature a symmetrical 45° side angle.

Self-powered Loudspeakers

Powered NuQ loudspeakers feature very efficient integrated Class D amplifiers and control electronics modules, providing a completely self-contained professional sound system. The XLR inputs are electronically balanced and are wired pin 2 hot, pin 3 cold, and pin 1 ground. Amplifiers will operate over a range of mains input voltages from 100V to 240V AC without adjustment.

Connect the mains power using the supplied Powercon mains lead. Check that the mains lead is suitable for use in your area before connecting.

Connect the signal input from a professional mixing console to the signal in XLR, and link out to additional powered loudspeakers if required

Power up the loudspeaker. It will un-mute after a short self-test routine; the loudspeaker is now ready for use

The B-12DP features an on-board amplifier configured to drive NuQ-6 or other satellite loudspeakers, as well as its own internal 12” LF driver. The amplifier is also equipped with four factory presets with differing band gains which allow for different configurations of satellite speakers. These are selectable via a push switch that toggles around the four available presets, and these are listed below. Presets 2 to 4 are user editable using TurboDrive software.

Preset number	Function	User editable?
Preset #1	B-12DP plus 2 x NuQ-6 satellite loudspeakers	No – factory default
Preset #2	B-12DP plus up to 6 x NuQ-8 satellite loudspeakers	Yes
Preset #3	B-12DP plus 2 x NuQ-8 satellite loudspeakers	Yes
Preset #4	B-12DP plus 2 x any passive satellite loudspeakers	Yes

Networking Capability

NuQ systems are designed to offer control and monitoring of system parameters over a BvNet network in real time using a PC and TurboDrive™ software. LMS-D2X controllers are equipped with network cards and are pre-configured with factory programs for all NuQ series models. Self-powered NuQ loudspeakers have built-in network functionality.

Download the TurboDrive™ software from the supplied CD or from www.turbosound.com and follow the installation instructions

Install the drivers. If connecting via RS232 there is no need to install drivers. If connecting via USB install the USB drivers which can be found on the CD that came with your Linea Research USB interface

Networking multiple devices to a PC: BvNet is the method of connecting multiple devices – these can be controllers and/or powered NuQ loudspeakers – and this is done with the Linea Research USB & RS232 Interface (available from Turbosound). The interface enables devices to be connected to a PC either using RS232 or using USB. RS485 is the

NuQ Quickstart Guide v1.2 - Page - 2