Xante 100-100621 manual Network administrator. Save the file to your c\ drive

Installation - Windows NT/2000/XP (continued)

Fig. 85 Print Test Page. Click Next.

Fig. 86 Setup Complete. Click Finish.

Configuring IP, SubNet, and Gateway Addresses

1.From the ps_files folder on the XANTÉ CD-ROM, copy dhcpoff.ps to your c:\ drive.

2.Go to DOS (Command) Prompt.

3.Type copy dhcpoff.ps lpt1.

4.Power cycle the printer (turn off, then back on).

5.Using a word processing application, open setipsub.ps file from the ps_files folder. Edit the file so it contains the IP, Subnet, and Gateway address you obtained from your

network administrator. Save the file to your c:\ drive.

6.Go to DOS (Command) Prompt.

7.Type copy setipsub.ps lpt1.

8.Power cycle the printer again and verify that the start-up page contains your IP, Subnet, and Gateway addresses.

9.Go to DOS (Command) Prompt to ping the printer.

c:\ping (IP Address)

Note: If you can ping the printer, go on to step 10. If you cannot ping

your printer, contact your Network Administrator.

10.Go to your Printer Properties (fig. 87) and select the Port Tab (fig. 88).

21