Philips FW-V55 manual KEY Control I È Digit 0, ¤ Echo -/+, Zoom, Vocal Digest, Ë, etc

English

CONTROLS

	for CLOCK	to set the minute (on	⁄	KEY CONTROL ( I È i )		° DIGIT 0 – 9
) MIC LEVEL		the system only).	–	to change the key to suit your vocal		(numbers consisting more than two
				range (for VCD operation only).		figures must be keyed in within 2
–	to adjust the mixing level for karaoke			I	to decrease vocal key	seconds.)
	or microphone recording.				level.	for VCD with PBC on
¡ MIC				È	to restore vocal key to	to select an entry level.
–	to connect microphone jack.				original setting.	for VCD/CD/MP3-CD…to key in a disc
™	VOLUME			i	to increase vocal key	track to start playback
–	to increase or decrease the volume.				level.	or
£	DYNAMIC BASS BOOST (DBB)		¤ ECHO -/+			...................... to select another track
–	to select a bass boost level or to		–	to adjust the echo level for karaoke		during playback or
	switch off bass boost.			(for VCD operation only).		...................... to select a track for
≤ OPEN			‹ RESUME			programming.
–	to open tape deck 2.		–	to continue playback again from		· B
∞	TAPE DECK 2			where you have stopped. Only when		– to switch the system to standby mode.
§	TAPE DECK 1			PBC mode is switched off (for VCD
≥	OPEN			operation only).
–	to open tape deck 1.		› SLOW
•	OSD (ON SCREEN DISPLAY)		–	to watch a VCD at a slower speed.
–	to switch on or off the on screen			There are 3 modes of selection (for
	display on the TV screen.			VCD operation only).
ª ZOOM			fi A - B
–	to enlarge a still picture on the TV		–	to playback a certain scene or passage
	screen (for VCD operation only).			of a VCD/CD repeatedly.
º VOCAL			fl DIGEST			Notes for remote control:
–	to fade out the vocal of the original		–	to scan through a VCD or a particular		– First select the source you wish to
	song during VCD playback or to switch			track. There are 4 modes of selection		control by pressing one of the
	between mono or stereo mode during			(for VCD operation only).		source select keys on the remote
	audio disc playback (for VCD operation		‡ REPEAT			control (e.g. VCD, TUNER, etc.).
	only).		–	to repeat a disc track or the current		– Then select the desired function
				disc.		(É, í, ë, etc.).

10

pg 01-28/V55/21-En 10 6/8/01, 9:11 AM 3139 115 20042