Fragment Threshold | To fragment MSDU or MMPDU into small sizes of | |
| frames for increasing the reliability of frame (The | |
| maximum value of 4096 means no fragmentation is | |
| needed) transmission. The performance will be | |
| decreased as well, thus a noisy environment is | |
| recommended. |
|
RTS Threshold | This value should remain at its default setting of | |
| 4096. Should you encounter inconsistent data | |
| flow, only minor modifications of this value are | |
| recommended. |
|
Preamble | A preamble is a signal used in wireless environment | |
| to synchronize the transmitting timing including | |
| Synchronization and Start frame delimiter. (Note: If | |
| you want to change the Preamble type into Long or | |
| Short, please check the setting of AP.) | |
Authentication | The authentication type defines configuration | |
| options for the sharing of wireless networks to | |
| verify identity and access privileges of roaming | |
| wireless network cards. |
|
| You may choose between Open System, Shared | |
| Key, and Auto Switch. |
|
| Open System: If the Access Point is using "Open | |
| System" authentication, then the wireless adapter | |
| will need to be set to the same authentication type. | |
| Shared Key: Shared Key is when both the sender | |
| and the recipient share a secret key. | |
| Auto Switch: Select Auto Switch for the adapter to | |
| select the Authentication type automatically | |
| depending on the Access Point Authentication type. | |
Retry limits | You can set the number of retries if no | |
| acknowledgement appears from the receiving | |
| station. |
|
Antennas | To set the type of the antenna | |
| Tx Antenna:Antenna2 (Use | the factory default) |
| RX Antenna:Both (Use | the factory default) |
802.11g version | This section is enabled only with | |
| Mode |
|
- 23 -