3.Attach squeeze bulb assemb ly to Spy Camera
a.Locate end of tubing not attached to squeeze bulb. (Figure 4)
b. Insert the tube into the hole on back side of the camera.Twist and push until the plastic tip is firmly seated.(Figure 5)
Figure 4
Figure 5
SECRET STORAGE COMPARTMENT
The Spy Camera comes with a secret storage compartment disguised as a film cartridge. Please note this is not film.It is used to store loose change or other small items.It needs to be removed from the camera so that you can load the film in its place.
TO LOAD 110 FILM CARTRIDGE
1. Remove film from packaging.
2.Locate the door on the back side of the camera.(Figure 6) 3.Place finger in door groove and pry open.
4.Look at the film and locate the end with a raised up notch on it.
5.Position film as shown on the camera door diagram,or in Figure 6,and insert in the camera. 7.Close door.
8.Locate the advance winder on the bottom front side of the camera.(Figure 7)
9.With your finger, rotate the advance winder down until it stops. Your camera should be ready to take pictures.
10.To Check that you have properly loaded the film,check the back side of the camera door.The
number “1” should appear in the little window. (Figure 8)Figure 6
HOW TO T AKE GREAT SPY PICTURES
A large viewfinder has been included with the Spy Camera so you can easily take photos.
1. Put on sunglasses with Spy Camera attached.
2.Flip down viewfinder in front of the left lens on the sunglasses.It should click into position. 3.Check to verify that film,is advanced and ready.
4.Place squeeze bulb in your hand.
5.Find the subject you wish to photograph.
6.Center it within the viewfinder on your left eye. (Figure 9)
7.Squeeze the Squeeze Bulb.You will hear a click sound which indicates the picture has been taken. 8.Rotate the advance winder downward until it stops.The next picture Frame number will appear throught the camera window.
9.Find a new subject and repeat the steps to take a picture. | Figure 7 |
|
(Hint:when you are not taking pictures, you can flip the viewfinder up out of your way. Just rotate it up.) |
| Advance Winder |
|
| |
|
|
TO UNLOAD 110 FILM CARTRIDGE:
1.Advance the Winder until it stops and nothing shows through the window on the camera door. 2.Open camera door.
3.Remove film.It is now ready to be developed.
Note:When the film is developed,each picture will be framed with a black “Spy Cam” border as shown in Figure 10.
Spy Camera
Figure 8
Figure 9
WARNING:
Figure 10
CHOKING HAZARD: Small Parts Not for Children Under 3 Yrs.