Position the antennas near the cable entry point. Here the TravelNet unit was located in the front overhead (Figure 1) with the antennas mounted close by on the roof.
Figure 2
Note that the antenna mounts are anchored to the 7” x 7” aluminum ground plane and that everything is well sealed.
Figure 3
3.Insert the small end of the cable through the ¾” diameter hole in the stainless antenna mount and feed the cable through. Next screw the brass antenna mount nut to the antenna mount as shown above, with the
Ver. 1.5 |
|
4/21/2009 | - 3 - |