Lenovo S6000L manual Removing and replacing an FRU

Page 30

Lenovo IdeaTab S6000L Hardware Maintenance Manual

Removing and replacing an FRU

This section presents exploded figures with the instructions to indicate how to remove and replace the FRU. Make sure to observe the following general rules:

1.Do not attempt to service any computer unless you have been trained and certified. An untrained person runs the risk of damaging parts.

2.Before replacing any FRU, review “FRU replacement notices” on page 25.

3.Begin by removing any FRUs that have to be removed before the failing FRU. Any of such FRUs are listed at the top of the page. Remove them in the order in which they are listed.

4.Follow the correct sequence in the steps to remove the FRU, as given in the figures by the numbers in square callouts.

5.When turning a screw to replace an FRU, turn it in the direction as given by the arrow in the figure.

6.When removing the FRU, move it in the direction as given by the arrow in the figure.

7.To put the new FRU in place, reverse the removal procedures and follow any of the notes that pertain to replacement. For information about connecting and arranging internal cables, see “Locations” on page 36.

8.When replacing an FRU, use the correct screw as shown in the procedures.

DANGER

Before removing any FRU, turn off the computer, unplug all power cords from electrical outlets, remove the battery pack, and then disconnect any of the interconnecting cables.

Attention: After replacing an FRU, do not turn on the computer until you have made sure that all screws, springs, and other small parts are in place and none are loose inside the computer. Verify this by shaking the computer gently and listening for rattling sounds. Metallic parts or metal flakes can cause electrical short circuits.

Attention: The system board is sensitive to, and can be damaged by, electrostatic discharge. Before touching it, establish personal grounding by touching a ground point with one hand or using an electrostatic discharge (ESD) strap (P/N 6405959) to remove potential shock reasons.

26

Image 30
Contents IdeaTab S6000L Page Contents About this manual Lenovo IdeaTab S6000LSafety information General safety Electrical safety Lenovo IdeaTab S6000L Hardware Maintenance Manual Safety inspection guide Grounding requirements Safety notices multilingual translations Safety noticeLenovo IdeaTab S6000L Hardware Maintenance Manual Safety information Lenovo IdeaTab S6000L Hardware Maintenance Manual Safety information Lenovo IdeaTab S6000L Hardware Maintenance Manual Safety information Laser compliance statement Safety information Important service information Before replacing partsStrategy for replacing FRUs Important service information Important notice for replacing a system boardImportant information about replacing RoHS compliant FRUs Original partGeneral checkout Following are not covered under warranty What to do firstApproximate information about the battery status Power system checkoutChecking the internal battery status Accurate information about the battery statusLenovo IdeaTab S6000L Hardware Maintenance Manual Security Related service informationPower management Activating/Deactivating the DisplaySpecifications Feature DescriptionLenovo IdeaTab S6000L Plastic to plastic FRU replacement noticesScrew notices Logic card to plasticRemoving and replacing an FRU Back cover Step Screw quantity Color TorqueLenovo IdeaTab S6000L Hardware Maintenance Manual Battery pack Removal steps of battery packSIM card and SD card Removal steps of SIM card and SD cardSystem board Important notices for handling the system boardRemoval steps of system board G g g g Back camera Sub board Removal steps of sub boardLocations Front viewRight-side view Back view Parts list Overall Lenovo IdeaTab S6000L Parts list-Overall AC adapters USB CableScrew Power cords Parts list-3-pin power cordsLenovo IdeaTab S6000L Lenovo IdeaTab S6000L Hardware Maintenance Manual Page Trademarks