Outback Power Systems HUB4, MATE_B, HUB10, MATE2 user manual HUB 10 PCB

Page 11

Series/Parallel location

Three-Phase location

4.Move the plug-in jumper from the series/parallel location to the three-phase location.

5.Replace the PCB and bottom cover, the snap on wiring cover, and all CAT5e cables..

For three-phase stacking using a HUB 10, follow the same disassembly and assembly instructions as for a HUB 4, but note that the jumper is in a different location as shown below.

HUB 10 PCB

Plug-in jumper

Jumper in series/ parallel location

Jumper in three-phase location

Image 11

Contents HUB Contact Information About OutBack Power SystemsDisclaimer Dear OutBack Customer Warranty IntroductionAccordance with EN EU Declaration of ConformityCommunications Manager Outback HUBIntroduction Mounting AccessoriesHUB 10 and HUB 4 Parts HUB Ports HUB Connecting to the HUBHUB Operation Common Wiring Configurations Three-Phase Stacking Only HUB 10 PCB FLEXware 1000 System Sample Network ConfigurationMate Power Up Press the Mate soft key Adding a Device to an Operating HUBAction TroubleshootingProblem TWO Year Limited Warranty Information Revision.2008-04-01 HUB Communcations Manager Limited Warranty RegistrationPage REV B