Panasonic AW-DU600P manual Menuj 4Input J 2 3 2 C R S j 4 2, Menuj Output-1 J 2 3 2 C R S j 4 2

Connections

Connection procedure

1.Connect the AW-PS301 AC adapter to the DC 12V IN connector on this adapter.

2.Set the control panel selector switch on this adapter to B.

3.1 Connect the PAN/TILT CONTROL OUT connector on the control panel to the PAN/TILT CONTROL IN connector on this adapter using a 10 BASE-T (equivalent to UTP category 5) straight cable.

The connection distance can be extended up to 500

meters.

2Connect the CAMERA CONTROL OUT connector on the control panel to the CAMERA CONTROL IN connector on this adapter using a coaxial cable (equivalent to 5C-2V).

The connection distance can be extended up to 500 meters.

<Note>

This connection is not possible with the AW-RP301 control panel as it is not equipped with a CAMERA CONTROL OUT connector.

3When a PC is used as the control panel, connect it to the TO RCB/PC connector on this adapter.

4.Set the power switch on this adapter to ON.

5.Dial Up Adapter settings

1 Set this adapter to direct mode.

Press the MENU+ key ( 2 i START ) to open the menu settings.

When “Menu-1 Function” appears on the LCD panel,

use the !			# keys and select
	START	STOP
Direct (direct mode).
Menuj 1		Function
T x	R x	D i r e c t

2Select the connector for input of control signals from the controller.

Press the MENU+ key ( 2 i START ) to change

the menu setting item.

“Menu-4 Input” appears on the LCD panel.

Select the CONTROL OUT connector to be used

using the !			# keys.
	START	STOP

When control is to be performed from a control panel, select RS-422 and select RS-232C when it is to be performed from a PC.

Menuj 4Input

R S j 2 3 2 C R S j 4 2 2

3Set the CONTROL OUT connector according to the type of pan-tilt connected and the connection distance.

Press the MENU+ key ( 2 i START ) to change the menu setting item.

When “Menu-5 Output-1” appears on the LCD panel,

use the !			# keys and select
	START	STOP

RS-232C or RS-422 according to the pan-tilt head system to be connected.

	Menuj 5		Output-1
	R S j 2 3 2 C R S j 4 2 2
6. When the settings are completed, press the
					MENU+
key ( 2 i			) once again to exit	the menu
		START
settings.

7.Set the power switch on the pan-tilt head to ON.

8.Set the POWER switch on the control panel to ON to control the pan-tilt head system. When an AW-RP505 is being used as the control panel, select the pan-tilt head system using the CONTROL button on the control panel.

9.When the POWER switch on the control panel is set to OFF after control of the pan-tilt head is completed, the power of pan-tilt head system will turn off.

16