Panasonic KV-S2045CU, KV-S2025CU installation manual How to replace the fuse

Page 6

Notice

(For United Kingdom only)

For your safety please read the following text carefully.

This appliance is supplied with a moulded three pin mains plug for your safety and convenience.

A 5 amp. fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fuse has

a rating of 5 amps. and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark or the BSI mark on the body of the fuse. If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A

replacement fuse cover can be purchased from your local Panasonic Dealer.

If the fitted moulded plug is unsuitable for the socket outlet in your home then the fuse should be removed and the plug cut off and disposed of safely.

There is danger of severe electrical shock if the cut off plug is inserted into any 13 amp. socket.

If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a qualified electrician.

WARNING: This appliance must be earthed.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following code.

Green-and-Yellow

: Earth

Blue

: Neutral

Brown

: Live

As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows.

The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug which is marked with the letter E or by the Earth symbol or coloured Green-and-Yellow.

The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the letter N or coloured Black.

The wire which is coloured Brown must be connected to the terminal in the plug which is marked with the letter L or coloured Red.

How to replace the fuse :

Open the fuse compartment with a screwdriver and replace the fuse.

6

Image 6
Contents Model No. KV-S2025C / KV-S2025CU KV-S2045C / KV-S2045CU KV-S2025C KV-S2025CU KV-S2045C KV-S2045CUSystem requirements CPUTable of Contents Warnung For United States onlyAvertissement HinweisSvenska How to replace the fuse English Roller cleaning paper precautions Advertencia Precautions This will void your warrantyPrecautions ≥Power SourceCD-ROM Document guides Component IdentificationKV-S2025C / KV-S2025CU Paper feed rollerComponent Identification Feed extension trayComponent Identification Power turn-on sequence About LEDComponent Identification About the Scsi setting Scsi ID SettingScsi Terminator Setting Loading Documents Loading Documents Types of documents to avoid Clearing Paper Jams Removing paper jams from the feed partClearing Paper Jams Cleaning the Unit Outside of the scannerInside the scanner Cleaning the Unit Cleaning the rollers and sensors Roller cleaning paperCleaning the Unit Clean the reflector sheet for the ending sensorCleaning the CIS glasses and sensor rollers CIS glass front Replacing Consumables Replacing the paper feed roller moduleReplacing Consumables Close the ADF door Replacing Consumables Replacing the retard roller module Close the retard roller cover Close the ADF door How to re-attach the sensor rollers Re-attach the sensor roller for front scanningRepacking Instructions Please NoteMaterials Required Repacking Instructions KV-S2045C / KV-S2045CU Specifications Model No KV-S2025C KV-S2025CU KV-S2045C KV-S2045CU ItemsSpecifications Troubleshooting Symptom Possible Cause RemedyTroubleshooting See page 27Index Page Page Panasonic Canada Inc