Panasonic CQ-VX100W Observe the following warnings when installing, Use the proper power supply

Page 2

English

1

Safety Information

Read the operating instructions for the unit and all other components of your car audio system carefully before using the system. They contain instructions about how to use the

system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual.

This manual uses pictographs to show you how to use the product safely and to alert you to potential dangers resulting from improper connections and operations. The meanings of the pictographs are explained below. It is important that you fully understand the meanings of the pictographs in order to use this manual and the system properly.

 

This pictograph intends to alert you to the pres-

 

 

This pictograph intends to alert you to the pres-

 

ence of important operating instructions and

 

 

ence of important operating instructions and

Warning

installation instructions. Failure to heed the

 

Caution

installation instructions. Failure to heed the

instructions may result in severe injury or

 

instructions may result in injury or material dam-

 

 

 

 

death.

 

 

age.

 

 

 

 

 

Warning

Observe the following warnings when using this unit.

The driver should neither watch the display nor operate the system while driving.

Watching the display or operating the system will distract the driver from looking ahead of the vehicle and can cause accidents. Always stop the vehicle in a safe location and use the parking brake before watching the display or oper- ating the system.

Use the proper power supply.

This product is designed for operation with a negative grounded 12 V DC battery system. Never operate this product with other battery systems, especially a 24 V DC battery system.

Protect the Deck Mechanism.

Do not insert any foreign objects into the slot of this unit.

Do not disassemble or modify the unit.

Do not disassemble, modify the unit or attempt to repair the product yourself. If the product needs to be repaired, consult your dealer or an authorized Panasonic Service Center.

Do not use the unit when it is out of order.

If the unit is out of order (no power, no sound) or in an abnormal state (has foreign objects in it, is exposed to water, is smoking, or smells), turn it off immediately and consult your dealer.

Refer fuse replacement to qualified service per- sonnel.

When the fuse blows out, eliminate the cause and have it replaced with the fuse prescribed for this unit by a qualified service engineer. Incorrect replacement of the fuse may lead to smoke, fire, and damage to the product.

Observe the following warnings when installing.

Disconnect the lead from the negative (–) battery terminal before installation.

Wiring and installation with the negative (–) battery termi- nal connected may cause electrical shock and injury due to a short circuit.

Some cars equipped with the electrical safety system have specific procedures of battery terminal disconnection.

FAILURE TO FOLLOW THE PROCEDURE MAY LEAD TO THE UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETY SYSTEM RESULTING IN DAMAGE TO THE VEHI- CLE AND PERSONAL INJURY OR DEATH.

Never use safety-related components for installa- tion, grounding, and other such functions.

Do not use safety-related vehicle components (fuel tank, brake, suspension, steering wheel, pedals, airbag, etc.) for wiring or fixing the product or its accessories.

Installing the product on the air bag cover or in a location where it interferes with airbag operation is prohibited.

Check for piping, gasoline tank, electric wiring, and other items before installing the product.

If you need to open a hole in the vehicle chassis to attach or wire the product, first check where the wire harness, gasoline tank, and electric wiring are located. Then open the hole from outside if possible.

Never install the product in a location where it inter- feres with your field of vision.

Never have the power cord branched to supply other equipment with power.

After installation and wiring, you should check the normal operation of other electrical equipment.

The continuation of their using in abnormal conditions may cause fire, electrical shock or a traffic accident.

In the case of installation to an airbag-equipping car, confirm warnings and cautions of the vehicle manufacturer before installation.

Make sure the leads do not interfere with driving or getting in and out of the vehicle.

Insulate all exposed wires to prevent short circuit- ing.

2

CQ-VX100W

Image 2
Contents Model CQ-VX100W Do not use the unit when it is out of order Observe the following warnings when installingUse the proper power supply Protect the Deck MechanismInstallation Angle Observe the following cautions when using this unitFollow the instructions to install and wire the prod- uct Take care not to damage the leadsSafety Information Before Reading These Instructions ComponentsFeatures Contents Radio radio settings a Other SettingsDisc disc settings a PreparationDisc Marks Symbols used in this manualPictographs Name of Controls and Functions Remove the Face Plate Install the Face PlateFace Plate Removal Alarm Touch Panel Operation Overview State of Operation ScreenVideo Source Switching the DisplayAudio Source General Operations PowerGeneral Display Open/CloseFolding Down VolumeTilt Angle Display TemporarilyBefore Disc Playback Discs that can be Played BackDisc Eject DVD VCD When a disc is in the playerDisc Insert/Eject Because a disc is already loadedDisc Player VCD Video CD DivXBasic Operations From a specific Chapter/title SelectionShowing menu Chapter/titleUseful Function Displayed items CommonDivX Displayable charactersSupported file systems No warrantyCopyright Maximum number of files/foldersTuning RadioPreset Station Calling Preset MemoryAuto Preset Memory Preset Swap¡Connect an optional external device to the AV1/AV2 ¡You can set up the system so that the AV mode is notPreparation AV1/AV2 onEnglish Settings Touch Operation Screen Setup OperationExample setting screen Exit from the menuID-Code AdjustClock DisplayOther InputMemory Clear Aspect DimmerDisplay Balance/Fader Subtitle Language Video SettingAudio Language Menu LanguageAuto Preset Audio SettingFM Setup DivX RegistrationTouch . w Touch Disc About DivX VOD ContentDisplay the unit’s registration code Troubleshooting ACheck the speaker wiringDisplay does not go Back into the unit Check the wiring of the antenna power leadPicture is dark. Picture is whitish. SomethingThere is a flaw or foreign objects on the disc Audio format is output disabled for this unit such as dtsDisc has unplayable formatted data Picture may stop if the DivX files are greater than 2 GBCase you forget the ID code Error Display MessagesDivX VOD content has no available play count ID code memoProduct Servicing MaintenanceCleaning this Unit Replacing the FuseDVD-Rs/RWs Code Language Name Language Code ListOther cases... a Letterbox screen Dolby DigitalInteractive DVD Lpcm Linear PCM audioVp-p 75 Ω ¡Video input signal Composite video signal ¡S/N ratioKHz 1 602 kHz Vrms H x D 154 x 87 x 177 mmYFM264C059CA PTW1107-1018