zReorient or relocate the receiving antenna.
zIncrease the separation between the equipment and receiver.
zConnect the equipment into an outlet on a circuit differ- ent from that to which the receiver is connected.
zConsult the Panasonic Service Center or an experi- enced radio/TV technician for help.
Warning
To assure continued compliance, use only shielded inter- face cables when connecting to a computer or peripheral. Also, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired oper- ation.
FCC RF Exposure Warning:
zThis equipment is provided with PC Card slot that could be used with wireless transmitters, which will be specifically recommended when they become avail- able.
Other
may not comply with FCC RF exposure requirements. <Only for model with wireless LAN/Bluetooth>
zThis equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
zThis equipment has been approved for mobile opera- tion, and unless otherwise advised in separate supple- mental instructions for individual wireless transmitter(s), requires minimum 20cm spacing be pro- vided between antenna(s) and all person’s body (excluding extremities of hands, wrist and feet) during wireless modes of operation.
zThis equipment may not be
<Only for model with wireless LAN>
This product is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz frequency range.
FCC requires this product to be used indoors for the frequency range 5.15 to 5.25 GHz to reduce the potential for harmful inter- ference to
Responsible Party: Panasonic Corporation of North Amer- ica One Panasonic Way
Secaucus, NJ 07094
Tel
<Only for model with modem> FCC Regulation Notice for modem
This equipment contains a FCC approved modem.
1.This equipment complies with CFR47 Part 68 rules.
On the computer is a label that contains, among other infor-
mation, the FCC registration number and ringer equivalence number (REN) for this equipment. If required, this informa- tion must be provided to the telephone company.
2.An FCC compliant telephone cord and modular plug is pro- vided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack which is Part 68 compliant. See Installation Instructions for details.
3.The REN is used to determine the quantity of devices which may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all area, the sum of RENs should not exceed five (5.0). To be certain of the num- ber of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company.
4.If your telephone equipment cause harm to the telephone network, the telephone company will notify you in advice that temporary discontinuance of service may be required. But if advice notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
5.The telephone company may take changes in its facili- ties, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.
6.If trouble is experienced with this equipment, for repair or warranty information, please contact Panasonic Corporation of North America at DIAL TOLL FREE
7.There are no user serviceable parts contained in this equipment.
8.This equipment may not be used on coin service pro- vided by the telephone company. Connection to party lines is subject to state tariffs.
9.The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or other electronic device to send any message via a telephone fax machine unless such message clearly contains in a margin at the top or bottom of each transmitted page or on the first page of the transmission, the date and time it is sent and an identification of the business or other entry, or other individual sending the message and the telephone number of the sending machine or such business, other entity, or individual. In order to pro- gram this information into your fax software, you should refer to the manual of the Fax software being used.
10.According to the FCC’s electrical safety advisory, we recommend that you may install an AC surge arrestor in the AC outlet to which this equipment is connected. Telephone companies report that electrical surges, typ- ically lightning transients, are very destructive to cus- tomer terminal equipment connected to AC power sources and that this is a major nationwide problem.
“Caution : To reduce the risk of fire, use only No.26 AWG or larger (e.g., 24 AWG) UL listed or CSA certified tele- communication line cord.”
“ATTENTION : Pour réduire le risque d’incendie, utiliser uniquement des conducteurs de télécommunications 26 AWG ou de section supérieure (p. ex. 24 AWG) UL énumérés ou CSA certifié.”
Appendix Troubleshooting Useful Information Getting Started
5