Panasonic Troubleshooting CF W2 Battery Issues and Standby Functionality
Page 52

Dealing with Problems (Summary)

‹Standby/Hibernation Function

Unable to automatically enter

z If a peripheral is connected to the computer, disconnect the device

standby or hibernation mode

z When the internal LCD is closed, the computer may not enter standby or

 

hibernation mode. In order to activate standby or hibernation automatically

 

while using the computer with the internal LCD closed, set [Touch Pad] to

 

[Disable] in the [Main] menu of the Setup Utility.

 

z If there is a disk in the DVD-ROM & CD-R/RW drive that has been formatted

 

using B’s CLiP, the computer will not enter standby or hibernation mode.

 

Remove the disk.

The computer does not resume

z Did you disconnect the AC adaptor or the battery pack while the computer

 

was in standby mode? If the computer's power supply is disconnected while

 

the computer is in standby mode all unsaved data will be lost.

 

z Did you slide the power switch and hold it for four seconds or more? If so,

 

the power will be turned off forcibly. In this case, all unsaved data will be

 

lost.

 

 

‹Battery Indicator

The red indicator is lit

z The battery level is very low (the charge is approx. 9% or less).

 

z Connect the AC adaptor. You can use the computer when the indicator light

 

is orange. If you do not have an AC adaptor, save your data and power off

 

your computer. After replacing the battery pack with a fully charged one,

 

turn your computer on again.

The red indicator blinks

z Quickly save your data and power off your computer. Disconnect the AC

 

adaptor and remove the battery pack, then connect them again. If the prob-

 

lem persists, contact your technical support office. The battery pack or

 

charging circuit may be defective.

The orange indicator blinks

z Battery cannot be recharged temporarily because the internal temperature

 

of the battery pack is beyond the acceptable temperature range for recharg-

 

ing. Once the allowable range requirement is satisfied, charging begins

 

automatically. Your computer can be used normally in this state.

 

 

‹Onscreen Reference Manual

Troubleshooting

The Reference Manual is not dis- played

zIs Adobe Reader installed?

If you have uninstalled Adobe Reader, install using the following proce- dures.

ALog on to Windows with the administrator authority.

BClick [start] - [Run], input [c:\util\reader\AdbeRdr60_enu_full.exe], then click [OK].

Install Adobe Reader by following the instructions on the screen.

CUpdate Adobe Reader to its latest version.

If your computer is connected to the Internet, start up Adobe Reader and click [Help] - [Update].

If your computer is not connected to the Internet, click [start] - [Run], input [c:\util\reader\Acro-Reader_6.0.2_Update.exe], then click [OK].

‹Disk Operations

If the DVD-ROM & CD-R/RW drive

z Is the disk bent or labeled?

vibrates excessively or is noisy

z Check to see if the disk is inserted correctly, and it is in good condition. If the

 

disk is good and inserted correctly, set [CD/DVD Drive Speed] to [Low] in the

 

Setup Utility (Î page 33).

 

z When writing to CD-R/RW using B's Recorder, you can minimize vibration

 

while writing by setting the writing speed at [8x] or less.

 

 

52

Page 51 Page 53
Image 52
Page 51 Page 53
Contents Personal Computer Model No. CF-W2 Series Copyright IntroductionDisclaimer Trademarks Read Me First For U.S.AFor Canada Read Me FirstIndustry Canada IC Notice for modem Industry Canada Information to the User Lithium BatteryDVD-ROM & CD-R/RW Drive Caution ‹Usage Precautions‹Handling Clean the DC plug of dust and other Do not do anything that may damageAC cord, the DC plug, or the AC AdaptorPrecautions Wireless LAN Turn off*1 inside of airplanesPrecautions Battery Pack Usage Precautions / About Notations Usage Precautions‹When closing the disk cover About NotationsManual Types and Contents How to Use This ManualHow to Use the Onscreen Manual Features Names and Functions of Parts DVD-ROM & CD-R/RW Confirm the Status Using the LEDs Indicators Indicator Name/StatusTurn the computer over and insert the battery pack First-time OperationConfirm the inclusion of all parts Read the Limited USE License Agreement ÎConnect your computer to a power outlet First-time OperationOpen the display Turn your computer onSetup Windows ‹This concludes the first-time use operation guidelines Create User Accounts to recognize this computers userPassword Reset Function Screen DisplayRoles of Icons on the Notification Area Starting Up/Shutting Down Starting UpLog-on to Windows Select your applicationShutting Down power off your computer ‹To shut down using the keyboardStarting Up/Shutting Down Click Turn Off‹When you leave the computer or interrupt your work Using the Touch Pad ‹When the cursor doesn’t move the way you want it to Using the Fn Key Power off your computer. Î Expanding MemoryInserting / Removing the RAM Module ‹Inserting‹Removing Expanding MemoryPut the cover back in place Setup Utility Running the Setup UtilityHow to use the screen Setup UtilityKey Operations Information Menu Main MenuAdvanced Menu LANSecurity Menu Boot Menu Boot MenuExit Menu Usage / Handling / Maintenance MaintenanceUsage Environment HandlingUseful Information Operation Wireless LAN About Turning On/Off the Wireless LAN‹Turning on/off the Wireless LAN ‹Enable/disable wireless LAN standard IEEE802.11a 802.11a‹Use Fast User Switching Windows/Antivirus ProtectionWindows Change the Way Users Log on or offWindows/Antivirus Protection Security Center/Antivirus ProtectionWindows Security Center If the message Your computer might be at risk is displayedPop-up Blocker Windows UpdateComputer Viruses Using CD/DVD ‹Before using the drive‹While the DVD-ROM & CD-R/RW drive is being accessed ‹About recognition of mediaWhen Using Peripheral Devices When Changing Hard Disk PartitionsInternal Hard Disk To Protect DataWhen Disposing of This Computer List of Error Codes ‹Windows Setup Dealing with Problems Summary‹Starting Up ‹Enter Password Dealing with Problems Summary ‹Display‹Shutting Down ‹Setup Utility‹Standby/Hibernation Function ‹Onscreen Reference Manual ‹Battery Indicator‹Disk Operations ‹Reinstalling B’s Recorder/B’s CLiP ‹SD Card Setup SD Memory Card security function‹Fast User Switching Function ‹Wireless LAN‹Other Problems Ctrl Shift EscCheck the Computer’s Usage Status ‹Running PC Information Viewer‹Save information to a file ‹Save a copy of the screen to a fileInformation for Installed Applications Getting Started TroubleshootingReinstalling Software Before ReinstallationReinstalling Software ReinstallingChange the settings in the Setup Utility Connect the AC adaptorUse the Product Recovery DVD-ROM to execute reinstalla- tion Return the Setup Utility settings to their default values If you can connect to the Internet, perform Windows Update ‹Changing the drive letterLimited USE License Agreement About Intel software productsLicense Contrat de licence dusage limitéTermes, clauses et conditions Before Using a Hard Disk Backup Function Hard Disk Backup FunctionPreparing Create a Backup Area Hard Disk Backup Function Backing Up and Restoring Data Enter keyTo disable the hard disk backup function When the hard disk backup function has been enabledHard Disk Data Erase Utility Before Erasing DataCompletely Erasing Data ‹Confirm the followingsHard Disk Data Erase Utility Important Information Specifications Main SpecificationsImportant Information Specifications Pre-installed SoftwarePage Index
Top Page Image Contents