NOTE
zRegarding backup area
•Requires availability of at least half of the entire hard disk. Without sufficient space available, the backup area cannot be created.
•When the backup area is created, the usable hard disk capacity will be reduced to less than half.
•The backup area cannot be accessed from Windows. For this reason, backed up data cannot be copied to
•When the hard disk backup function is executed, data in the backup area will be overwritten. If newly created or edited data is backed up later, data stored previously in the backup area will be lost.
Create a Backup Area
ATurn the computer on, and press the F2 key while [Panasonic] boot screen is displayed.
The Setup Utility will start up.
If a password has been set, enter the Supervisor Password. You cannot register [Boot] menu with a User Password.
BSelect the [Boot] menu, then select [CD/DVD Drive] and press the F6 key until [CD/DVD Drive] is at the top of the [Boot] menu.
CPlace the Product Recovery
•When the disk cover does not open:
[CD/DVD Drive Power] has been set to [Off] in the [Main] menu. Perform the following procedure.
Set [CD/DVD Drive Power] to [On].
Press the F10 key.
At the confirmation message, select [Yes] and press the Enter key. The computer will restart.
Press the F2 key while [Panasonic] boot screen is displayed. The Setup Utility will start up.
Set the Product Recovery
DPress the F10 key.
At the confirmation message, select [Yes] and press the Enter key. The computer will restart. If [Enter Password] is displayed during the fol- lowing procedures, input the Supervisor Password or the User Password. This screen should appear.
EPress the 3 key to execute [3. [Backup]].
CAUTION
zWhen dividing the hard disk into partitions
Do not execute [1. [Recovery]] to divide the hard disk into partitions. The hard disk backup function cannot be enabled after the hard disk has been partitioned. Use step G to divide the hard disk.
Important Information
65