Panasonic CF-F9 appendix Read Me First, Models for U.S.A, Quency Interference Statement

Read Me First

Models for U.S.A.

<Only for model with a “ ” mark on the bottom of the computer>

Federal Communications Commission Radio Fre-	<Only for model with wireless WAN>
quency Interference Statement	z This product is restricted to indoor use due to its oper-
Note: This equipment has been tested and found to com-	ation in the 5.15 to 5.25 GHz frequency range.
	FCC requires this product to be used indoors for the
ply with the limits for a Class B digital device, pursuant to	frequency range 5.15 to 5.25 GHz to reduce the poten-
Part 15 of the FCC Rules. These limits are designed to	tial for harmful interference to co-channel Mobile Satel-
provide reasonable protection against harmful interfer-	lite systems. High power radars are allocated as
ence in a residential installation. This equipment gener-	primary users of the 5.25 to 5.35 GHz and 5.65 to 5.85
ates, uses and can radiate radio frequency energy and, if	GHz bands. These radar stations can cause interfer-
	ence with and /or damage this product.
not installed and used in accordance with the instructions,
	25-M-W-3
may cause harmful interference to radio communications.
	Responsible Party: Panasonic Corporation of North America
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does	One Panasonic Way
cause harmful interference to radio or television recep-	Secaucus, NJ 07094
tion, which can be determined by turning the equipment	Tel No:1-800-LAPTOP5 (1-800-527-8675)
off and on, the user is encouraged to try to correct the	6-M-1
interference by one or more of the following measures:	FCC Regulation Notice for modem
z Reorient or relocate the receiving antenna.
	This equipment contains a FCC approved modem.
z Increase the separation between the equipment and
receiver.
z Connect the equipment into an outlet on a circuit differ-
ent from that to which the receiver is connected.
z Consult the Panasonic Service Center or an experi-	1. This equipment complies with CFR47 Part 68 rules.
enced radio/TV technician for help.
	On the computer is a label that contains, among other
Warning	information, the FCC registration number and ringer
	equivalence number (REN) for this equipment. If
To assure continued compliance, use only shielded inter-
	required, this information must be provided to the tele-
face cables when connecting to a computer or peripheral.
	phone company.
Also, any changes or modifications not expressly
	2. An FCC compliant telephone cord and modular plug is
approved by the party responsible for compliance could
	provided with this equipment. This equipment is
void the user’s authority to operate this equipment.
	designed to be connected to the telephone network or
This device complies with Part 15 of the FCC Rules.	premises wiring using a compatible modular jack
Operation is subject to the following two conditions:	which is Part 68 compliant. See Installation Instruc-
(1)This device may not cause harmful interference, and	tions for details.
	3. The REN is used to determine the quantity of devices
(2)This device must accept any interference received, includ-
	which may be connected to the telephone line. Exces-
ing interference that may cause undesired operation.
	sive RENs on the telephone line may result in the
FCC RF Exposure Warning:	devices not ringing in response to an incoming call. In
z This equipment is provided with PC Card slot that could	most, but not all area, the sum of RENs should not
be used with wireless transmitters, which will be specif-	exceed five (5.0). To be certain of the number of
ically recommended when they become available.	devices that may be connected to a line, as determined
Other third-party wireless transmitters have not been	by the total RENs, contact the local telephone company.
RF exposure evaluated for use with this computer and	4. If your telephone equipment cause harm to the tele-
	phone network, the telephone company will notify you
may not comply with FCC RF exposure requirements.
	in advice that temporary discontinuance of service
<Only for model with wireless LAN/Bluetooth>
	may be required. But if advice notice isn’t practical, the
z This equipment complies with FCC radiation exposure
	telephone company will notify the customer as soon as
limits set forth for an uncontrolled environment.
	possible. Also, you will be advised of your right to file a
z This equipment has been approved for portable opera-
	complaint with the FCC if you believe it is necessary.
tion, and does not require any minimum spacing be
	5. The telephone company may take changes in its facili-
provided between antennas and all person’s body.
	ties, equipment, operations or procedures that could
z This equipment may not be co-located or operated
	affect the operation of the equipment. If this happens
with any other antenna or transmitter.
	the telephone company will provide advance notice in
25-M-3	order for you to make necessary modifications to
<Only for model with wireless WAN>
	maintain uninterrupted service.
z This PC with WWAN transmitter installed, has been	6. If trouble is experienced with this equipment, for repair
approved for mobile operation and to assure compli-	or warranty information, please contact Panasonic
ance with RF exposure requirements, a minimum of 20	Corporation of North America at DIAL TOLL FREE 1-
cm (8 inches) must be maintained between the WWAN	800-LAPTOP5 (1-800-527-8675). If the equipment is
antenna located in top of LCD and all person’s body	causing harm to the telephone network, the telephone
(excluding extremities of hands, wrist and feet) during	company may request that you disconnect the equip-
wireless modes of operation.	ment until the problem is resolved.

Appendix Troubleshooting Useful Information Getting Started

3