Error Code/Message
Troubleshooting Useful Information Getting Started
Appendix
Follow the instructions below when an error message or code appears. If the problem persists or if the error code/mes- sage is not shown here, contact Panasonic Technical Support (Î page 29).
Error Code/Message | Solution | ||
0211 Keyboard error | z Disconnect external keyboard or mouse. | ||
0251 System CMOS | An error has occurred in the memory of Setup Utility settings. This occurs when the memory | ||
checksum bad - | content is changed by an unexpected program operation, etc. | ||
Default configuration | z Start the Setup Utility and return the settings to the default values, and then change the | ||
used | settings as necessary. | ||
| z If the problem persists, the internal clock battery may need to be replaced. Contact | ||
| Panasonic Technical Support (Î page 29). | ||
|
| ||
0271 Check date and | The date and time settings are not correct. | ||
time settings | z Start the Setup Utility and set the correct date and time. | ||
| z If the problem persists, the internal clock battery may need to be replaced. Contact | ||
| Panasonic Technical Support (Î page 29). | ||
|
| ||
0280 Previous boot | Startup has failed repeatedly, so the Setup Utility settings have been returned to the default | ||
incomplete - Default | values to startup the computer. | ||
configuration used | z Start the Setup Utility and return the settings to the default values, and then change the | ||
| settings as necessary. | ||
Press <F2> to Setup | z Write down the error details and press |
| to start the Setup Utility. Change the settings if |
F2 | |||
| necessary. | ||
|
| ||
Operating System not | The operating system is not installed in the floppy disk or the hard disk that you are going to | ||
found | boot from. | ||
| z If using a floppy disk, change the disk to the one you can use for boot. | ||
| z If using the hard disk, check if the hard disk is recognized in [Information] menu of the | ||
| Setup Utility. If the hard disk is recognized, perform the reinstallation (Î page 18). If not, | ||
| contact Panasonic Technical Support (Î page 29). | ||
| z If a device is connected to the USB port, disconnect the device, or set [USB Port] or | ||
| [Legacy USB Support] to [Disable] in [Advanced] menu of the Setup Utility. | ||
RAM Module Failed | When the RAM module is not inserted correctly or the RAM module is not conforming to the | ||
| computer’s specifications, so a beep will sound and the “RAM Module Failed” message will | ||
| be displayed when you turn the power on. |
zPress the power button for four seconds or longer to turn off the computer, confirm that the RAM module conforms to the specifications, and reinsert it.
To start the Setup Utility
ARestart the computer.
BPress F2 several times while [Panasonic] boot screen is displayed soon after the computer begins the startup procedure.
20