Panasonic CF-74ECBGDBM manual Stuck key

Page 15

6List of Error Codes <Only when the port replicator is connected>

The following is a list of the messages that BIOS can display. Most of them occur during POST. Some of them display information about a hardware device, e.g., the amount of memory installed. Others may indicate a problem with a device, such as the way it has been configured. Following the list are explanations of the messages and remedies for reported problems.

If your system displays one of except the messages marked below with an asterisk (*), write down the message and contact Panasonic Technical Support. If your system fails after you make changes in the Setup menus, reset the computer, enter Setup and install Setup defaults or correct the error.

0200 Failure Fixed Disk

Fixed disk in not working or not configured properly. Check to see if fixed disk is attached properly. Run Setup. Find out if the fixed-disk type is correctly identified.

0210 Stuck key

Stuck key on keyboard.

0211 Keyboard error

Keyboard not working.

0212 Keyboard Controller Failed

Keyboard controller failed test. May require replacing keyboard controller.

0213 Keyboard locked - Unlock key switch

Unlock the system to proceed.

0230 System RAM Failed at offset : nnnn

System RAM failed at offset nnnn of in the 64k block at which the error was detected.

0231 Shadow RAM Failed at offset : nnnn

Shadow RAM failed at offset nnnn of the 64k block at which the error was detected.

0232 Extended RAM Failed at offset : nnnn

Extended memory not working or not configured properly at offset nnnn.

0250 System battery is dead - Replace and run SETUP

The CMOS clock battery indicator shows the battery is dead. Replace the battery and run Setup to reconfigure the system.

*0251 System CMOS checksum bad - Default configuration used

System CMOS has been corrupted or modified incorrectly, perhaps by an application program that changes data stored in CMOS. The BIOS installed Default SETUP Values. If you do not want these values, enter Setup and enter your own values. If the error persists, check the system battery or contact Panasonic Technical Support.

0260 System timer error

The timer test failed. Requires repair of system board.

0270 Real time clock error

Real-time clock fails BIOS test. May require board repair.

*0280 Previous boot incomplete - Default configuration used

Previous POST did not complete successfully. POST loads default values and offers to run Setup. If the failure was caused by incorrect values and they are not corrected, the next boot will likely fail. On systems with control of wait states, improper Setup settings can also termi- nate POST and cause this error on the next boot. Run Setup and verify that the wait-state configuration is correct. This error is cleared the next time the system is booted.

0281 Memory Size found by POST differed from EISA CMOS

Memory size found by POST differed from EISA CMOS.

6-1

Page 14 Page 16
Image 15
Page 14 Page 16
Contents CF-74ECBGDBM Page Laser Safety Information Page Page Contents High-Speed CD-RW 4X/10X Bluetooth*12 Version 2.0+EDRJack, 3.5 DIA, Impedance 32 Ω, Output Power 4 mW × Model NoOperation has been tested and confirmed using Panasonic Maximum resolution depends on the specificationsOnly for model with wireless LAN Only for model with BluetoothNames and Functions of Parts Right side Block Diagram Page Troubleshooting Outline of Post Error Diagnosis by Checking Beep Signal SoundTable of errors classified by beep sounds Diagnosis Beep signal sound Error messageStuck key 02D0 System cache error Cache disabled Self Diagnosis Test Operation of PC-Diagnostic Utility PC-Diagnostic utility End method Content of the setup is returned to the setting of the userSelection of tested device Ty of breakdown Content of standard test Content of enhancing testRecord area frequently accessed All record area is tested Test item StanardTest Item Content of Standard Test Content of Extend TestExpress Card Connector Wiring between Super I/OWiring Connection Diagram HDD Unit Battery PackPreparation Removing the HDDRemoving the Dimm Memory Card Removing the KeyboardRemoving the Speaker and the LED PCB Removing the Main PCB Removing the Bottom CaseRemoving the PC Card Ejector and Lithium Battery Removing the FAN Motor and SD PCBRemoving the DC-IN PCB and I/O Removing the LCD and the Inverter Removing the USB PCBRemoving the Display unit Removing the LCD Front CabinetRemoving the Touch PAD and PAD PCB Removing the Finger PCBPreparation Setting the Finger PCB Setting the LCD Unit InverterPreparing and setting the Finger Sensor Base Attaching the LCD Damper C and LCD Damper D Arranging the W-LAN L and R CableAttaching the Cloth Arranging the LCD/TS CableSetting the Inverter and Arranging the Inverter Cable Arranging the TP Power Cable and Attaching the TP/LCD SheetLCD Rear Cabinet Ensure all the 23 Hooks are securely set Setting the LCD Front CabinetSetting the Display unit Fixing of the LCD Front CabinetUSB Cable Tape Setting the USB PCBSafety Working MP Slide Sheet Arranging the USB CablePipe Sheet Setting the SD PCB, Heat Sink and FAN MotorApplying Grease on the Heat Sink Fan Dust SheetINV. Cable Setting the DC-IN PCB and I/O PCBArranging the DC-IN Cable FAN Cable Sheet DC-IN Cable ~3mmLithium Battery Setting the PC Card Ejector and Lithium BatterySetting the Main PCB Arranging the Lithium Battery Safety WorkingFAN Motor Main PCB Tape No.1 LAN Cable No.8 TP Power CableFAN Cable Connector CN28 Arranging the FAN CableBad example Setting the Wireless Module and MDC ModuleArranging the Modem Cable Good exampleSetting the Handle Assy Setting the Bottom CaseRed Line Setting the Speaker and the LED PCBSoldering the Speaker Cable and Setting the Speaker Rubber SpeakerCenter Cover Hooks KBD Angle L Keyboard KBD Angle R Setting the KeyboardSetting the HDD Setting the Dimm Memory Card and Dimm CoverSet the DVD-ROM Driver Unit Set the HDD Pack Exploded View 10-2 Screw tightening torque 10-310-4 K17-7 K17-6

CF-74ECBGDBM specifications

The Panasonic CF-74ECBGDBM is a rugged laptop designed to cater to the demanding needs of professionals who work in challenging environments. Built with durability as a top priority, this device serves as an ideal solution for industries such as public safety, construction, and field service.

One of the standout features of the CF-74ECBGDBM is its rugged design. The laptop is compliant with military standards, specifically MIL-STD-810G, ensuring it can withstand harsh conditions. This includes resistance to drops, vibration, dust, and moisture, allowing users to operate it in rain or shine without fear of damage. The spill-resistant keyboard adds another layer of protection, making it suitable for environments where liquids are prevalent.

In terms of performance, the CF-74ECBGDBM is equipped with a powerful processor, which provides efficient multitasking capabilities. The device typically features an Intel Core i5 processor, enabling smooth operation of demanding applications. Coupled with a sufficient amount of RAM, users can expect enhanced speed and productivity, even when running multiple programs simultaneously.

The laptop features a sunlight-readable display, which ensures visibility in bright outdoor conditions. The screen is designed to reduce glare, making it user-friendly for professionals who work outside regularly. Additionally, the display is supported by a durable touchscreen option, allowing for easier navigation in various working conditions.

Storage is another critical aspect of the CF-74ECBGDBM, as it often comes with solid-state drive options that not only provide ample memory for files and applications but also enhance the overall speed and reliability of the system. Users can rely on fast read and write speeds, which are essential for data-heavy tasks.

Connectivity options are abundant on this device, featuring USB 3.0 ports, HDMI output, and options for mobile broadband. This allows users to connect various peripherals or external displays easily, as well as maintain seamless internet access on the go.

Furthermore, the CF-74ECBGDBM is equipped with a long-lasting battery that supports extended periods of use, ideal for professionals who spend time away from traditional power sources. The device is designed for easy serviceability, facilitating upgrades and repairs, which enhances its lifespan in demanding workplaces.

Overall, the Panasonic CF-74ECBGDBM stands out as a robust and versatile laptop that meets the needs of users in tough outdoor and industrial settings, making it a reliable companion for professionals on the move.
Top Page Image Contents