Other operations for connection

Operations when password entry is required for connection

A [] mark is displayed for projectors that have passwords set.

The window shown to the right appears to establish a connection. Enter the password for the projector and click [OK].

(Password setting → See page 56)

•Click [CANCEL] at the <Password Input> window to return to launcher canceling the connection. (See page 32)

•When an incorrect password is entered, an error message appears.

Click [OK] to return to the <Password Input> window and enter the correct password again.

Other search

Apart from “Easy Wireless Set Up” (See page 15), there are 3 other ways to search for and connect to a projector, namely “Search by IP address”, “Search by domain name”, and “Search by ID”.

These methods can be used if you cannot search using “Easy Wireless Set Up”.

• Search by IP address	Search for and connect to a projector from the IP address※.
	The projector that you want to connect to must have a network number of [USER1]-[USER3] and
	must have the IP address set. (See pages 52, 53)
• Search by domain name	Search for and connect to a projector from the domain name※.
	The projector that you want to connect to must have a network number of [USER1]-[USER3] and
	must have the IP address set. (See pages 52, 53)
	※ “Glossary” (See page 70)
• Search by ID	Even if there are two or more projectors with the same name, an ID ([Proj] + 4-digit number) is
	assigned to each projector to enable the projectors to be identified.
	A search for the projector of the specified ID is carried out from among the projectors that are
	presently switched on, from all network numbers other than [USER1]-[USER3].
	It is necessary to know ID in advance. When input selection is switched to [NETWORK] on a
	projector, the ID appears on the upper right of the projection screen for approximately 5 seconds. If
	you write down the ID displayed in the [ID] column of the <Projector Search> window in advance,
	you can search a projector by the ID from next time.

1	Click [ ] at the <Projector Search> window.
	<Other search> window appears.
2	Enter the information of the projector you want to
	search for, and select the search criteria.

• When using “Search by IP address”

A Enter the IP address (including its periods). Example: 192.168.10.100

B Select [Search by IP address]

• When using “Search by domain name” A Enter the domain name.

B Select [Search by domain name].

• When using “Search by ID” A Enter the ID.

B Select [Search by ID].

Other search

Search by IP address

Search by domain name

Search by ID