Using the remote control unit

<Connector panel>

# $ %		& '
L

AUDIO		AUDIO
		PC IN
R	VIDEO S2 VIDEO	PC IN
	VIDEO S2 VIDEO
	VIDEO IN

()

AUDIO
	PB/CB
R	PB/CB
	PR/CR

COMPONENT IN

Inserting the battery

Insert the lithium battery which is supplied with the remote control unit, making sure that the polarities are correct.

#While pushing the battery holder tab to the right, pull out the battery holder.

Operating range

If the remote control unit is held so that it is facing directly in front of the front remote control signal receptor, the operating range is within approximately 7 m (23´) from the surfaces of the receptors. Furthermore, the remote control unit can be operated from an angle of

Preparation

#AUDIO L-R input jacks (for VIDEO/S-VIDEO)

(page 18)

Only one system is provided, so connect the appropriate connector when using VIDEO or S-VIDEO.

$VIDEO input jack (page 18)

This jack is used to input video signals from a video equipment such as a video deck.

%S2 VIDEO input connector (pages 18 and 30)

This connector is used to input signals from an S-VIDEO- compatible equipment such as a video deck. The connector is compatible with S2 and S1 signals, and projector aspect is automatically adjusted according to the type of signal received.

&AUDIO input jack (for PC) (page 19)

'RGB input connector (page 19)

This connector is used to input RGB signals from a PC.

(AUDIO L-R input jacks (for

YPBPR) (page 20)

)YPBPR(CBCR) input jacks (page 20)

These jacks are used to input YPBPR signals from compatible equipment such as DVD players.

Push the tab

Pull out

$Insert the battery into the battery holder so that the “+” side is facing upwards.

Match the “+” surface of the battery with the “+” marked side of the battery holder.

%Insert the battery holder.

NOTE:

BDo not drop the remote control unit.

BKeep the remote control unit away from liquids.

BRemove the battery if not using the remote control unit for long periods.

BUse only CR2025 batteries as replacement batteries.

±30 ° to the left or right and ±15 ° above or below the receptors.

NOTE:

BIf there are any obstacles in between the remote control unit and the receptors, the remote control unit may not operate correctly.

BIf strong light is allowed to shine onto the remote control signal receptor, correct remote control operation may not be possible. Place the projector as far away from light sources as possible.

BIf facing the remote control unit toward the screen to operate the projector, the operating range of the remote control unit will be limited by the amount of light reflection loss caused by the characteristics of the screen used.