Panasonic PT-EX16K manual Response data Data section Blank Mode Termination symbol

Control commands via LAN (continued)

When WEB Control administrator rights password is not set (Non-protect mode)

Connection method

1)Obtain the IP address and port number (Initial set value = 1024) of the projector and make a request for connection to the projector.

Acquire the IP address from the menu screen of the projector, and the port number from the WEB control page.

IP address : Obtain from MAIN MENU → [Network] → [Network status]

Port No. : Acquire from the WEB control “Detailed set up” → “Command port setting” page

2) There is a response from the projector.

Response data

Data section	Blank	Mode	Termination symbol
“NTCONTROL”	‘  ’	‘0’	(CR)
(ASCII string)	0x20	0x30	0x0d
9 bytes	1 byte	1 byte	1 byte

Mode : 0 = Non-protect mode

Command transmission method

Transmit by the following command format.

Transmitted data

Header		Data section	Termination symbol
‘0’	‘0’	Control command	(CR)
0x30	0x30	(ASCII string)	0x0d
1 byte	1 byte	Undefined length	1 byte
Receive data
Header		Data section	Termination symbol
‘0’	‘0’	Control command	(CR)
0x30	0x30	(ASCII string)	0x0d
1 byte	1 byte	Undefined length	1 byte
Receive data
	Error message		Termination symbol
“ERR1”	Undefined control command
“ERR2”	Out of parameter range
“ERR3”	Busy state or no-acceptable period		(CR)
“ERR4”	Timeout or no-acceptable period		0x0d
“ERR5”	Wrong data length
“ERRA”	Password mismatch
	4 bytes		1 byte

25