Power Input, Speaker Output and Fusing

RSd AMPLIFIERS

MONOBLOCK OWNER’S MANUAL

��

POWER INPUT

8.GROUND INPUT TERMINAL (B-)

To be wired to the vehicle’s chassis for ground.

9.REMOTE TURN-ON INPUT TERMINAL (R)

To be connected to the remote control wire or power antenna lead of the source unit for remote ON/OFF.

10. POWER INPUT TERMINAL (B+)

To be connected to the positive terminal of the vehicle’s battery or other constant +12 V source. Remember to fuse at 12+ source.

��

SPEAKER OUTPUT AND FUSING

11.AMP FUSE

Protects the ampliﬁer. If a replacement is necessary, use the same size and type indicated on the end panel. Never use a fuse with a higher amp rating.

12.PROTECT LED

Red light: Ampliﬁer is in protection - Overheated (will resume play on its own), Low voltage, Shorted terminal

No light: Ampliﬁer is functional (when power is on)

Note: “Power On” is indicated when the badge/logo on top of the ampliﬁer lights up blue

13.RMD PORT (RMD - SOLD SEPERATELY)

This connection allows for connection of our remote voltage display (optional), so that you can monitor the applied voltage at the ampliﬁer in real time.

14.LEFT/RIGHT SPEAKER OUTPUT TERMINAL

Used to connect the ampliﬁer to speakers. The minimum suggested speaker wire size is 16 gauge for stereo mode and 14 gauge if the ampliﬁer is going to be used in mono/bridged operation.

Phoenix Gold International, Inc. • 9300 North Decatur St. Portland, OR 97203 • 503.286.9300 • www.phoenixgold.com