Direction of Air Intake and Exhaust

S P E C F I L E

LCD Projector

PT-F200

Notes on Projector Placement and Operation:

The projector uses a high-wattage lamp that becomes very hot during operation.

Please observe the following precautions.

1.Never place objects on top of the projector while it is operating.

2.Make sure there is an unobstructed space of 500 mm (19-11/16˝) or more around the projector's exhaust open- ings. In addition to this space, also ensure that there is a sufficient work space for removing and installing the lamp, filter and other parts.

3.If the projector is placed in a box or enclosure, ensure the temperature of the air surrounding the projector is between 0°C/32°F and 35°C/95°F. Also make sure the projector’s intake and exhaust openings are not blocked. Take particular care to ensure that hot air from the exhaust openings is not sucked into the intake openings.

200 mm (7-7/8˝) or more

500 mm (7-5/8˝) or more

Intake

Exhaust

Operating the Projector Continuously

1.When the projector is operated continuously 10 hours or more, the lamp replacement cycle decreases.

2.The lamp replacement cycle also decreases when the projector is used for short periods of time (less than one hour) repeatedly.

Replacing the Filter Unit

The projector is equipped with the Auto Rolling Filter (ARF) function, which automatically winds the air filter to set a new filter element in place according to operating conditions. The filter unit replacement cycle ranges from approximately 6,000 hours maximum to approximately 500 hours minimum. Please purchase the ET-RFF100 filter unit for replacement use.

Weights and dimensions shown are approximate. Specifications are subject to change without notice. Product availability differs depending on region and country. This product may be subject to export control regulations. All other trademarks are the property of their respective trademark owners.

As of October 2008

< 10 >