Things You Should Know

6		Things You Should Know	Ò Things

6-A Battery

Recharge

When the RECHARGE indicator ﬂashes or the unit beeps intermittently, place the handset on the base unit for about 15 hours to recharge the battery.

RECHARGE

Indicator

Battery information:

After your Panasonic battery is fully charged:

Operation	Operating time

While in use (TALK)	Up to about 5 hours

While not in use (Standby)	Up to about 14 days

³The battery operating time may vary depending on usage conditions and ambient temperature.

³As preventative maintenance, clean the handset and the base unit charge contacts with a soft, dry cloth once a month. Clean more often if the unit is subject to grease, dust or humidity. Otherwise the battery may not charge properly.

³If the battery is fully charged, you do not have to place the handset on the base unit until the RECHARGE indicator ﬂashes. This will maximize the battery life.

³The battery cannot be overcharged.

6-B Battery Replacement

If the RECHARGE indicator ﬂashes after being fully charged, replace the battery with a new Panasonic P-P301 (KX-A36A) battery.

When replacing the battery, programmed information may be erased. Reprogram if necessary.

1 Press the notch on the handset cover ﬁrmly and slide it as indicated by the arrow.

2 Replace the battery and close the cover.

³Insert the battery plug into the connector as shown in the picture.

³Be sure wires are free from being pressed by the battery body or the handset cover.

Black	Red
Black	Lead	Make sure to charge
Lead	Lead
Lead
		3 the new battery for
		about 15 hours.

6-C Base Unit Location

Calls are transmitted between the base unit and the handset using wireless radio waves. For maximum distance and noise- free operation, the recommended base unit location is:

Away from electrical appliances	In a HIGH and CENTRAL
such as a TV, personal computer,	location with no obstructions
cellular phone charging units	such as walls.
or another cordless phone.

6-D Wall Mounting

This unit can be mounted on a wall.

1 Pull down the handset hook until it locks, so

the tab holds the handset.

Extend fully.

Screws
	8.3 cm
	For Australia
	To Telephone Plug
	and Socket
	OR
To Power	For New Zealand
To Power	To Single-Line
Outlet	Telephone Jack
	Telephone Jack

Wall Template

2 Install screws using the wall template below. Connect the AC adaptor and telephone line cord.

3 Mount the unit, then slide down.

³Extend the antenna fully.

8.3 cm

Ò Things