Zebra Technologies LP2443 user manual Step AutoSense Gap Sensor Adjustment

Page 14

Installation and Operation

Step AutoSense Gap Sensor Adjustment

Perform this procedure when loading a new roll. You cannot perform this procedure if using the printer’s label dispenser option.

Power OFF

Hold

Feed Button

Power ON

8	980176-001 Rev.E

Image 14

Contents Orion Thermal Printer User’s Manual Foreword Orion LP2443 Thermal PrintersWarranty Information Shock Hazard Warning Table of Contents 980176-001 Rev.E Installation and Operation Unpacking Your Printer Getting To Know Your Printer Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Parallel Interface Serial InterfaceOpen Cover Open Guides Install Roll Step ➌ Load LabelsLoad Labels Step AutoSense Gap Sensor Adjustment Power OFF Hold Feed Button Power onAutoSense Gap Sensor Adjustment Tap Feed Button To Begin Normal OperationLabel Dispenser Option Using Fan-Fold Media Insert Media Adjust Guides Adjust Holders Tighten ScrewStep ➎ Install Software Appendix a Troubleshooting REDCompuServe e-mail 102251,1164 Host Print Head Wait One Minute Before Closing Printer Cleaning Print HeadRub Cleaning Pen Appendix B Accessories World Wide Offices Zebra Technologies Corporation Eltron Products