Zebra Technologies LP2443 user manual Warranty Information

Page 3

WARRANTY INFORMATION

We Need To Hear From You!

To Establish Your Warranty Period And Provide Access To Technical Support,

Send Us Your Product Registration Card Today!

Zebra Technologies Corporation warrants the mechanism, control electronics and power supply, under normal use and service, to be free from defects in material and workmanship for a period of twelve (12) months from the date of purchase by the end user. Zebra Technologies Corporation warrants the print head, under normal use and service, to be free from defects in material and work- manship for a period of ninety (90) days or 30KM of printing (whichever occurs first) from the date of purchase by the end user. Proof of purchase or product registration is required. If proof of pur- chase or product registration cannot be established, shipment date to the original buyer (dealer or distributor) will be used to establish the warranty period.

Failure to exercise caution to protect the equipment from electrostatic discharge damage, adverse temperature and humidity conditions or physical abuse may void the warranty. Failure to use only Eltron brand approved media may void the warranty. Zebra Technologies Corporation will, at its option, repair or replace the equipment or any parts which are determined to be defective within this warranty period, and which are returned to Zebra Technologies Corporation F.O.B. factory of origin.

The warranty set forth above is exclusive and no other warranty, whether written or oral, is ex- pressed or implied. Zebra Technologies Corporation specifically disclaims the implied warranties of merchantability and fitness for a particular purpose.

RETURN MATERIALS AUTHORIZATION

Before returning any equipment to Zebra for in warranty or out of warranty repair, contact Repair Administration for a Return Materials Authorization (RMA) number. Repack the equipment in the original packing material and mark the RMA number clearly on the outside. Ship the equipment, freight prepaid, to the address listed below:

Zebra Eltron Repair Administration, USA

1001 Flynn Road

Camarillo, CA. 93012

Phone: +1 (805) 579-1800

FAX: +1 (805) 579-1808

Label Printers:

Card Printers:

Zebra Technologies, Europe

Zebra Technologies, Europe

Eltron House

Zone Indutrielle, Rue d'Amsterdam

Molly Millars Lane

44370 Varades, France

Wokingham RG41 2QZ England

Phone: +33 (0) 240 097 070

Phone: +44 (0) 1189 770 300

FAX: +33 (0) 240 834 745

FAX: +44 (0) 1189 895 762

 

980176-001 Rev.E

iii

Image 3
Contents Orion Thermal Printer User’s Manual Orion LP2443 Thermal Printers ForewordWarranty Information Shock Hazard Warning Table of Contents 980176-001 Rev.E Installation and Operation Unpacking Your Printer Getting To Know Your Printer Step ➊ Attach Power Supply To The Printer Parallel Interface Serial Interface Step ➋ Attach Interface CableStep ➌ Load Labels Open Cover Open Guides Install RollLoad Labels Power OFF Hold Feed Button Power on Step AutoSense Gap Sensor AdjustmentTap Feed Button To Begin Normal Operation AutoSense Gap Sensor AdjustmentLabel Dispenser Option Insert Media Adjust Guides Adjust Holders Tighten Screw Using Fan-Fold MediaStep ➎ Install Software RED Appendix a TroubleshootingCompuServe e-mail 102251,1164 Host Cleaning Print Head Rub Cleaning PenPrint Head Wait One Minute Before Closing Printer Appendix B Accessories Zebra Technologies Corporation Eltron Products World Wide Offices