Zebra Technologies LP 2824 manual Printing in Peel-Mode

Page 29

Printing in Peel-Mode
The optional dispenser allows you
to print in “peel-mode” where the
label backing follows a different path and
the labels are presented one at a time for
subsequent placement.
1.	Remove several labels from the
	backing material.
2.	Open the top cover.
3.	Open the dispenser door.
4.	Switch on the label-taken sensor.
5.	Insert the backing in front of the peel
	bar and behind the peel roller.
6.	Close the dispenser door.
7.	Close the top cover.
8.	Press the Feed button to advance the
	label.
During the print job, the printer will peel
off the backing and present a single label.
Take the label from the printer so it will
print the next label.
	MOVIE
980481-001A	21

Image 29

Contents

Zebra LP 2824 TM 980481-001A Proprietary Statement Shock Hazard Contents Operation & Options 980481-001A Vii 980481-001A Hello IntroductionWhats in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Loading Roll Media Adjusting the Roll HoldersPlacing the Roll in the Media Compartment Using the Guides Operator Controls Power SwitchFeed Button Status LightMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerParallel Interface Requirements USB Interface RequirementsEthernet Interface Requirements Serial Interface RequirementsUniversal Serial Bus USB Communications Communicating with the PrinterParallel Communications Internal ZebraNet PrintServer II Communications Serial Communications CommandAdjusting the Print Quality Adjusting the Print WidthThermal Printing Operation & OptionsReplacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980481-001A Cleaning MaintenanceMedia Path Considerations Cleaning Card ConsiderationsPrint Head Considerations Platen Considerations LubricationRemoval AssemblyReplacing the Platen Replacing the Print Head Removal Direct-Thermal LP ModelAssembly 980481-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling Print head is under temperature Print Quality ProblemsNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesInterfaces Universal Serial Bus USB ConnectorAppendix Host Parallel InterfaceZebraNet PrintServer II for Ethernet Networks Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector Printer Serial RJ-11 Alternative Connector980481-001A